CDI電子点火と本物WALBROキャブレター/ワットTurnigyた30ccガスエンジン

• Overall
• Quality
• Value

25cc not 30cc

Mar 15, 2022

This motor is falsely advertised. If you do the maths it is only 25cc not 30.
I'm keeping it because I have to pay the freight to return it. I don't know how the motor performs yet.
I give Hobbyking minus stars for their discretion.

• Overall
• Quality
• Value

25cc not 30cc

Mar 15, 2022

This motor is falsely advertised. If you do the maths it is only 25cc not 30.
I'm keeping it because I have to pay the freight to return it. I don't know how the motor performs yet.
I give Hobbyking minus stars for their discretion.

• Overall
• Quality
• Value

noy sure

Mar 14, 2022

you have to mount engine from the back

• Overall
• Quality
• Value

Update Review

Feb 21, 2022

After cleaning off all the silicon from the carb gaskets, I fitted a NGK spark plug, hooked up my electric 12V starter to a 5S lipo, (man this thing is tight) primed the fuel lines and rotated the engine back and forwards to make sure the carb drawing fuel. She kicked more or less straight away with full choke, hit a bit of throttle which incidentally turns the choke off, hit the starter again and away she went. This thing runs really well, mixture screws were fairly well set from factory. Yeah, this motor had never seen fuel despite the description stated on HK site, but I am impressed. I have now run 2 tanks through it at 30:1 and improving all the time. Sure, bit rough around the edges but all in all pretty good! Bolted to my Stinson Reliant so looking forward to the maiden.

• Overall
• Quality
• Value

Mixed 1st impressions

Jan 10, 2022

Like others, silicon everywhere on carb gaskets, why would they?? Cleaned it off completely as it was smeared everywhere! Definitely not a Walbro but a fairly good copy. There is a tiny Rexcel logo on the ignition module so it’s anyones guess what brand it could be but hey for the price, worth a shot. Haven’t started it yet so fingers crossed.

• Overall
• Quality
• Value

Motor quality seems to be ok, but ignition quit while trying to start. Junk

Aug 21, 2021

Good price but ignition didn't work for more than 10 minutes. So I would say not worth the money.

• Overall
• Quality
• Value

Turnigy 30cc Gas engine

Jun 17, 2021

Arrived quckly the engine is very tight will need electric starter untill its run in

• Overall
• Quality
• Value

Very cost-effective

Dec 27, 2020

cleaned the sealant off the back of carb,, fired right up.. vibration was real bad,, tried several props,,all shook super bad at idle,, had to return motor,, exchanged for a new one from china warehouse,, same thing..had to clean off sealant,, fired right up ,,this one was much better,,but still could see two props at idle,, high speed all looked good will mount this turnigy 30cc on my ultra stickand see how it pulls

• Overall
• Quality
• Value

.......

Sep 24, 2019

......

• Overall
• Quality
• Value

Got a bad one

Jul 10, 2018

The fittings for the ball bearing were so tight, the bearings were hardly moving, so the crankshaft was getting REALLY hot. Performance was very bad, even less than the RCF 26. After about ten minutes, the ignition died. After about twenty minutes the magnet flew out.
Even after 3 hours of break in, handstarting was impossible.