Turnigy AerodriveXp 28-36 SKシリーズシャフト

• Overall
• Quality
• Value

Customer Rated

Mar 12, 2011

Are there any specific shafts for this motor PRODUCT ID: T2836-1000 or will these shafts fit all?

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 16, 2011

This is what I am talking about HK.. A great priced, well balanced EDF motor shaft that can handle 4-cell batteries load with authority. I needed to put this motor in the 70mm EDF unit that HK provides. I also had to modify the motor shaft to a 4mm motor shaft. This was a easy fix. Casuse used this (Turnigy AerodriveXp 28-36 SK Series Shaft) Thanks to the those that recommended this to me, which fit perfectly. Great balance too. Now this motor perrrs with power. 5 Stars on this one for sure!

• Overall
• Quality
• Value

Customer Rated

Feb 14, 2011

The length of the shaft is 51 mm and the groove position is 11,5 mm from the end. The washer lock is included.

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 24, 2010

I order 1 to replace with my Turnigy 2836-2450. This 1 is 3mm shorter than the original. But still can use.

• Overall
• Quality
• Value

Customer Rated

Dec 08, 2010

This shaft is not as the photo. There is only 1 groove, the
picture shows 2 grooves. I needed a shaft to mount the
prop in the opposite/other direction from the motor,
so I needed that last groove on the shaft.I bought 3 they
are no good to me.

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 07, 2010

This shaft worked perfect on this motor-which is want I wanted-

http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=8138

• Overall
• Quality
• Value

Customer Rated

Aug 08, 2010

Wanted to use these on my Turnigy2836 brushless Outrunner 2350kv



The shaft is much shorter, the main reason I give this only 2 stars is that there is only 1 groove, the picture shows 2 grooves. I needed a shaft to mount the prop in the oposit/other direction from the motor, so I needed that last groove on the shaft. O

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 24, 2010

asse come gi detto di ottima finitura

• Overall
• Quality
• Value

Customer Rated

Jan 21, 2010

ended up ordering this for my 2836 3200kv Turnigy edf motor.

Shaft is a about 4mm longer than the original and will require either a couple of washers at the front of the motor under the circlip /or grinding a longer flat spot on the rear of the shaft so the grub screw has a flat bit to grab on the grub.

If you grind the shaft flat spot you wont need spacers on the front end.