Turnigyボルト2800mAhの4S 15.2V 65〜130℃の高電圧Lipolyパック

• Overall
• Quality
• Value

Customer Rated

Jun 21, 2016

Hard to give this lipo a good rating. I bought it and cycled it 3 times as the lipo gurus suggested. I charged to 4.30v per cell which is higher than normal but not to the full potential of this lipo. Charge amperage was 2C. I used it to test the wattage, amps and rpms of my jet and to set up the surface throws. It was then brought down to storage voltage for the winter.
A few months later when I went to resurrect it to fly, 2 of the 4 cells were dead. I did everything according to protocol and didn't even get to fly with this lipo.
When it was working, the performance was very good but again, it's now disposal bound after 5 cycles. Never again paying $61.32 for something I never got to fly with!
Going to a different lipo distributor and never looking back.

Cheers

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 30, 2015

Der erste Druck ist zwar schneller raus liegen aber danach trotzdem noch auf einem hohen Niveau. Besonders auffllig ist das niedrige Gewicht.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 14, 2015

This battery gives the peak in my EDF jet.Full power all over the capacity. Good deal. Recommended for High C-rate applications. Happy as of now and will see in future how they work after a number of cycles.

• Overall
• Quality
• Value

Customer Rated

Jun 20, 2015

WOW! More Power = More Fun!!!!
The power of the new battery technology is incredible.
With the throttle to WFO, people in the pits will know something is different!
Better flight times with less power drop off.
I would like a plastic safety cap for the high voltage plugs when not in use.

• Overall
• Quality
• Value

Customer Rated

Apr 20, 2015

Brutaler Druck im ersten Drittel der Entladung bei Ladung auf 4,35 V.Danach "Einbruch" auf das Niveo einen guten Standard Lipos.Sehr geringe Erwrmung.Balancer hat kaum Arbeit beim Laden.Einige Regler erkennen eine Zelle zuviel im Automode.Bei Billigreglern die keine manuelle Zellenwahl zulassen ein Problem da kurz nach dem Start der Unterspannungsschutz greift.Nicht unter 3,5 eher 3,6 Volt unter Last leerfliegen ! Danach deutlicher Drift und extrem schnelle Alterung der zellen......