Remember to correctly install this piece need this part TZ-V2 .50-TT & TT TZ-V2 .90 - Tail Pitch Control Lever and will not have to make any modifications
Recuerden que para instalar correctamente esta pieza necesitan esta parte TZ-V2 .50-TT & TZ-V2 .90TT - Tail Pitch Control Lever y no tendra que hacerle ninguna modificacionone of the best upgrades that could I have done my TZ
The .90 tail pitch lever is a good recomandation for this tail case. However, you need an additional 1mm thick washer between the lever and the tail case, because it binds and it's hard to move. With the washer, it's smooth.
The tail fin holes don't fit indeed within the case, you need to redrill 2 holes.
Another thing, the tail case holds on the boom by pressure with a screw on the side of the case. It's not enough, I almost crashed when the tail twisted at the moment I did a stall turn. There is a third hole for a screw on the case, so I drilled the tail boom and put a 3x5mm screw into the tail boom. It does the trick.Bearing block have got a space , the thail blade vibrate and tracking :( - Arkadaslar Rulman yataklarinda bosluk var ve titresim oluyor. kalitesi hicte beklendigi gibi degil.Nice bling upgrade for the TZ 50, metal seems to be OK, a bit soft but durable I suppose. If you have the newer "beefier" tail you would have to buy an "older" model tail slider, since the new one have a round wheel type like hirobbo's schuttle 2. Also the existing screws is to long and won't fit. Would need 3 * 3mm by 8mm bolts to fit the tail fin to the tail piece. Also would need to re-drill the holes since the hole locations are to high for the metal piece. Also locktite everything, seems the tail fits only half way thru on the pipe.Great upgrade to the stock plastic tail. V2 kits already comes with a thicker plastic tail. But this is the ultimate upgradeNice upgrade. Fits fine for Raptor 50 and Raptor E550. But you must change the lever to 90-size, also sold by HK. Remember to use threadlock.Ninos129 Nice upgrade,Its amazing how a little Bling can make this heli look the part.vertical tail fin won't fit also,screw holes too far apart and as for pitch slider arm you can try using TZ 1856 it is the pitch slider arm for TZ90 Size heliAwesome machining on this part. Well worth the investment, especially in colder climate areas for winter flying.