The KINGKONG Micro CC3D Flight Controller is used in the KINGKONG range of Multirotors.
This flight controller uses the powerful OpenPilot architecture and the cross-platform Ground Control Station (GCS). The OpenPilot project is trying to make Open Source much more user friendly. OpenPilot software is designed to be used by everybody!
A standard mini-USB cable (not included) is used to load the latest firmware and configure everything for your unique airframe.
This FC controller can be used as a replacement for a damaged one or to start you flying a new multirotor. It comes with a dampening mount.
Features:
• Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM.
• 3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.
• Tiny 4 layer PCB for superior electrical noise reduction and flight performance.
• Software support for Windows, Mac and Linux.
• Direct high speed USB support with no drivers required, a truly plug and play device.
• Spektrum satellite receiver support.
• Futaba S-BUS hardware support.
• Innovative Flexi-port technology for superior port flexibility.
• 4Mbits on-board EEPROM for configuration storage.
• 10 PWM outputs to servos, ESCs or for camera stabilization
Specs:
Size: 43 x 20 x 15mm
Weight: 7g
Included:
1 x KINGKONG Mini CC3D FC
1 x OpenPilot Serial Cable
1 x OpenPilot CopterControl RC Receiver Cable
1 x Dampening Mount
1 x Receiver Aerial Mount
