2.4ghz SuperMicro Systems - DSM2 compatibele ontvanger w / Brushed ESC, Linear Servo

• Overall
• Quality
• Value

rather good

Apr 21, 2017

If You have a Orange TX or DSX-6 I; program it in Mix 1 Rudd- Ail . Tried to send a photo but since this pages are so stupid to understand I could not do it under files.

• Overall
• Quality
• Value

rather good

Apr 21, 2017

If You have a Orange TX or DSX-6 I; program it in Mix 1 Rudd- Ail . Tried to send a photo but since this pages are so stupid to understand I could not do it under files.

• Overall
• Quality
• Value

Customer Rated

Aug 07, 2016

I bought one of these as a replacement for my night vapour. While it is not a direct replacement with a couple of small dabs of hot glue it can be fitted and it works. There is even a socket to plug in the lights. Be careful soldering on the motor wires, the solder tabs are very close to the gears on the linear servos.
A lot cheaper than the Horizon Hobby replacement board.

• Overall
• Quality
• Value

Customer Rated

Jan 18, 2016

After a few seconds use the direction servo sticks in one position and won't move until the unit is re-powered, after which it sticks again. It's a shame because the other servo works fine and the programming functions are good (swapping sticks etc.). No good with one broken servo though, so I wouldn't buy another and risk the same thing again.

• Overall
• Quality
• Value

Customer Rated

Jan 19, 2015

So, here it is. Hooked it up into my broken NE P51, and have to tell, spendt an hour by soldering that micro tips, but here we go and action. Works excellent and i won't brake my mini again. Fast servo and throtle response, no signal los. So for it's prize, don't be worry.

Take tady to mme. Vtsnno do padlho NE P51, a musm ct, e jsem strvil hodinu pjenim na mikroplokch, ale deme dl. Funguje perfektn a dal havrie se tak nebude opakovat. Rychl reakce serv i otek, bez problm se ztrtou signlu. Za ty penze, se nen eho bt.

• Overall
• Quality
• Value

Customer Rated

Aug 25, 2014

Come on Hobby King , users need info ! or you wont sell certain tech products, get the manual on line .ASAP. lost sales and unhappy customers are the result.

• Overall
• Quality
• Value

Customer Rated

Aug 06, 2014

Hi 2 of these arrived today, smaller than the ar6400 The on board servos are elevator (right stick) and rudder (left stick), if you want them both on one stick you will have to use the TX mixes You have to solder wires to the PCB onto the very small holes, if the motor is reversed just swap them round (or put a small connector inline) Binding is a bit of a pain, although it follows the normal Spektrum method, RX on first (with a fully charged battery of course), you get the red flashing, switch on the TX with the bind button pressed and eventually it will go out then come on solid, that means its bound to the TX There may be other functions but without a manual its difficult HK WHERE IS THE MANUAL?, PLEASE COPY AND PUT IN FILES SECTION