2.4ghz SuperMicro Systems - ontvanger, ESC en 2 x Lineaire servo's All-in-one (3ch)

• Overall
• Quality
• Value

Customer Rated

Jan 25, 2013

Bought this All-in-one with the associate module for JR and installed it in my new Turnigy 9XR. It too suffered from the now commonly reported 'cutting out issue' until I removed the bottom case of the module and installed it that way. Top plastic section still allows it to locate properly with the retaining clips. Result, much better contact with the pins and no drop outs. However the two servos map to Aileron and Rudder?! Humm. Am going to have to re-map a channel there somewhere.

Over all servo drive speed was outstanding and on-par with AR6000 series RX's. Power not so much, but going into a Micro DLG Im not overly concerned. Unit is very light and quiet (anyone who's owned AR6000's know they buzz and carry on even when still). Im impressed and will buy again.

• Overall
• Quality
• Value

Customer Rated

Nov 18, 2012

This has been a letdown for me...
I bought this along with the JR module to control a small glider. When I installed the module, I found that I had to cut out a section of the casing to get it in. It was fine once I did.

I then charged my battery with a DIY plug as the 1-4S charger that I got had no 1s plug, and plugged it into my receiver. I received no instructions on how to bind, so I spent 20 minutes looking online for instructions.

Once I binded it, the servo movements were jerky and troublesome at best. When I moved the servo too much, I lost connection to my Transmitter.

I finally installed it on my plane, and found that the servos can push barely anything, and lost signal if I was in the other room.

So after an afternoon of troubleshooting, they didn't work as expected.

I don't suggest these. Buy something better.

-SuperBarlow

• Overall
• Quality
• Value

Customer Rated

May 07, 2012

Flew my 25" 2 channel scale glider with this system using futaba module. The ariel was detached on receipt and I had to resolder it, otherwise it worked and bound with no problems. Servos have very little power so a friction free wire run to horns and free hinges(floppy disc plastic) is required. One servo seems more powerful than the other and they are a bit jerky in operation but centre well. Overall this is suitable for my application and I am happy with my purchase. Have not checked the systems range yet.