7mm AS150 Anti Spark Self Isolerende Bullet Connector (2 paar)
Deze connector is voorzien van een geïsoleerde tip om grote vonken stoppen hoger voltage toepassingen. Dit in combinatie met de plastic zelf isolerende lijkwade biedt een veilige en affectieve connector pakket zonder krimpkous nodig.
Gewicht ( g)
Замечательные разъемы. Пользуюсь уже 2 года в 6ти и 12ти баночном варианте. Очень удобно соединять между собой аккумуляторы, чтобы сделать 12 банок, избавился от всех переходников.I ordered a dozen of these for my 12S setups. You could use them even on a 6S setups. FWIW
Connect - the red connector should be plugged in LAST to prevent spark.
You want the Black wire as your ground and the first to connect
Compatible with up to 8AWG wireI bought this plugs in INT warehouse before. Now, finally they are available in europ. These plugs are of good quality and easy to solder. Due to the plastic housings they do not separate easily by themselves. Prfect. I use them in all my 6S applications, either in helicopters or as well in airplanes. Highly recommended product.Very nice quality, these connectors are the must for big models!
Exit the spark when you plug your batterie(s) and they looks very professional.Quality product and very easy to use. Good buyI have this very good and smart working Goldies. All that .skyfox60. said about them is right ** just want to say, that when you solder the side with the AntiSpark resistor inside, make sure that you put the female counterpart over before but without the outer plastic insulation, just the female metal plug. The reason is, that while soldering the male plug, its getting that hot - especialy when it comes to soldering fat 8AWG cables - that the AntiSpark insulator at the front is about to melt, swell and deform itself - the female over the male avoids this and spreads the soldering heat a bit...HTH, Frank.
A few points to note
1) The covers have a screw thread to hold them to the plugs & sockets (this should make assembly easier)
2) The pack has 2 pairs of connectors; E.G. 4 female connecters, 2 male spark suppressing connectors, 2 non spark suppressing connectors
3) An fully assembled connector (E.G. 1 male, 1 female all in thier cover) is 5cm long, and almost 14mm in diameter, this may make fitting them akward
N.B. I havn't fitted these yet, they are planned to be the final arming stage (for a 6cell 1.2KW Weston Hype); so need to be accessable, visible, drag free etc. see point #3I must say... wow. Very good connectors and you see the difference, once you plug it in the first time. Recommended Item. I use it on 6s and works very good.
Would like to see them in smaller sizes, too.