12 Channel 900Mhz Tx / Rx video-systeem met CCD-camera.Een hoog vermogen 1500mW Tx op 900MHz zorgt voor een zeer lange signaal bereik!In tegenstelling tot andere algemene systemen, hebben we een kabelboom geproduceerd en opgenomen met de camera, zodat de Tx en camera compatibel en op dezelfde spanning zijn.
Als u uw camera te kopen en Tx apart de stekker polariteit en spanningen kunnen zeer verschillend zijn.Inbegrepen.
1 x Sony CCD 1 / 3inch Camera
1 x 8-kanaals 900Mhz Video Transmitter (1500mW)1 x 900Mhz 12-kanaals video-ontvangerCamera spec.CCD-sensor Type: 1/3 kleuren SONY CCD
NTSC: 510 (H) * 492 (V) (inbegrepen)
PAL: 500 (H) * 582 (V)
Scanning systeem: interlaced scanning
Synchronisatie: Systeem: Inter
Horizontale resolutie: 420TV lijn
Minimale verlichting 0.01LUX / F1.2
DSP + CCD: CXD3142R + 405AK
S / N Ratio: 48dB
Gamma Wijziging: 0.45
Auto backlight compensatie: Auto
Lens: 3,6 mm
Ingangsspanning: 9 ~ 12.6V
Elektrische stroom 80MA
Elektronische sluiter: 1/50 (60) ~ 1 / 100,000s
Video-uitgang: 1,0 Vp-p composiet video
Operatie Temp .: -20 ~ 50
Maat: 38 * 38mm
Vliegtijd: Ongeveer 60min / 100mAh 3SFPV Tx Spec.
Kanaal: 8-Ch, AV-synchronisatieVermogen: 1500mW
Gewicht: 18gGrootte: 73x41x14mm
Frequentie: 0,9 g 0,910 g, 0.980G, 1.010G, 1.040G
Capaciteit ( mAh )
Gewicht ( g)
Once I changed the red and white wires going into the camera it worked superbly. The reason for four crowns on quality is due to needing to change the camera plug even though the narrative in product description states, "If you buy your camera and Tx seperately the plug polarity and voltages may be very different." Thank goodness when the jack was plugged into the camera and power applied it did not smoke the video board.el cuarto que pido. seria deseable unas antenas de polarizacion circularWired Backwards!!!
Have not had a chance to fly with this yet. Tested with the extra camera that came with it did not work. I looked closely and found out the plug that goes in the camera is (Wired Backwards)! I slipped the wires out of the connector and put them in the right order. Blammm Fixed...
Looks like it would be easy to remove Tx heatsink for other applications (void warrenty). Having a problem finding a small Antenna for the 330 Quad... Might have to save this for a 450 Quad I will be building next...
Just got this unit it came with a ERO plug no problem
cut off lead hooked up 12 v battery all channels work everything lights up BUT PICK think cam is bad used a smaller one i had work ok
have a back up cam on order hope its ok when it gets heR
SORRY HK BUT LOOKS GREAT BUT HAVE TO RATE IT LOWERUsed this in a Bixler with an old Optic 6 radio and a patch antenna. On my 9th flight out around three and a half miles, I lost control of the plane. Video was working till I dropped behind some hills. I dont think I would push the video much more than that. I'm now going to UHF and better OSD (return Home) so I will write another review later. Happy FPVing:)Mine was Doa
there are no instructions or paperwork with any specs, there isn't even any specs on the equipment itself.
I feel like I was scammed!I tried today in a 30cc gas plane...plane it didnt work well...
it crashed my 2.4 Jr 12x radio.... i tried in the field and detected the problem before flying...on the next time i will try a 72Mhz old style radio...Good product. I haven't tested it so much yet but when I going to test it next i going to put the antenna up in the air too get more range. Use 3 cell batteries to power reciver and transmitter.Works well, however on a gas (this doesn't occur with nitro) vehicle, the picture disappears at certain RPMs; also if the antennas are close enough, this system, although on a very different band, will disrupt a 2.4ghz signal to the point of signal loss almost instantaneous.i was very pleased! i plugged it into my laptop to fly it worked great ! one of the solders came lose on the wire harness but all else its great ! check out my video here http://www.youtube.com/watch?v=idEgOSDK4Ks