Corona DS-633BP Digital Servo 0.82kg / 0.12sec / 6,2 g
Operating Voltage: 4.8V / 6.0V
Operating Speed: 0.12sec.60º / 0.10sec.60º
Stall Koppel: .82kg.cm /.95kg.cm
Gewicht: 6,2 g
Dead Band: ≤5uSec
Connector draad: 215mm
Bedrijfstemperatuurbereik: -20C + 60c
Gewicht ( g)
I just did a bench test, since the servo seemed to be stronger than the specs say, and the torque (dynamic) was really 1.25kg/cm at 5V!!! Great servo for the buck...?? ????? ???? ?????. ??? ???? ?? ??? ??? ?? ???? ??? ????. ? ????? ?????.OK got these in my blaster in pod now too and they are great, the ones in the wings have 111 hours flying time in them.Overall great servo for small electric planes, though are not suitable for 1.5m DLG as the gears dont hold up to hard launches. Small,light,fast and with almost zero slop.Seems to be a good servo,
I have 2 in my blaster dlg wing and so flown 30hrs on them, fast and precise, torque seems adequate for the job but no stronger then it needs to be, so as long as .82kg/cm is enough for you these should be good.
BTW they have survived a crash and still work.Bench tested only but seem good as has been said, fast enough and accurate not sure how strong they are but time will tell. Gonna use them in my blaster dlg wing and will report again how it goes.Over all in consensus with Fireball. New benchmark for cheap DLG solution. Servos are extremely fast with very good response and centering. No noticeable slop. Nice super thin wiring with a total weight of 6.44g with servo arm. Nice set of supplied servo horns and even rubber grommets.Overall it is good servo: fast, precise, not so strong but sturdy for it size.
Inspection reveals this is GWS pico servo with new electronics.Vraiment un super servo.
retour au neutre impeccable,
puissant et precis.
je l'utilise aux ailerons sur mes F3P ( avion de moins de 100g)It is on me to write the first review... I received two of them yesterday. The first impression is quite good. They generally appear to be much better than other low cost ultra small servos. The movement is precise. The gear play is not zero but little. The torque appears to be as specified. I did not measure it but it seems to be enough for the use on aileron of a DLG. So far no long term experience but I am optimistic. Btw, they can be used together with servos like HXT500. I noticed earlier with other Corona digital servos that they disturb the power supply too much for parallel use of analog servos.