FLIP32 F3 AIO-Lite Flight controller met ingebouwde OSD

• Overall
• Quality
• Value

top

Aug 09, 2021

doet wat het moet doen

• Overall
• Quality
• Value

osd

Jun 27, 2021

How to set osd with cleanflight? Tutorial

• Overall
• Quality
• Value

Old version, poor documentation, limited number of UART´s

Nov 17, 2020

This is an old version, newer are F7. Poor documentation not describing how to connect. Only 3 UART´s limits number of external sensors.

• Overall
• Quality
• Value

Quick delivery

Apr 20, 2020

good quality, friendful FC, easy setup, I recommend it

• Overall
• Quality
• Value

Good but tricky

Apr 11, 2018

Many bad comments, due to people not understanding the board.
See here: http://nathan.vertile.com/blog/2016/04/11/airbot-flip32-f3-aio-lite-and-typhoon-4-in-1-esc/
What you have to do to talk to the board / flash it is:
solder pins on the large solder tabs
Connect jumpers as listed. i.e. a horizontal jumper top and bottom all the way to the left to connect the CP210x with UART1 (leftmost 2 pins - marked STM32 Rx+TX).
Power with bootloader pins connected. Remove the bootloader connection.
Select No reboot sequence + manual baud rate 256000 in iNav/BetaFlight/CleanFlight configurator.
Load SPRacingF3 firmware, and flash.
To flash OSD, move jumpers one pin right, connecting Mega328/Max to CP210x.
And finally to fly, move jumpers one place further right, connecting UART2 to the Mega328/Max.
Set UART2 to MSP.
Connect Rx to UART3, and GPS to UART1 (2 left pins)
Board supports external current monitor, and VBat monitoring. Must be powered by external source (PDB / Old school ESC).
The single row is pins for motors. If you want to use in plane, you have to break up the servo connectors. You can borrow 5V from the PWM receiver side rail. If you have soem dupon cable it is easy to move connector from the 3way servo connector to a 3way with 2 wires and a lose wire.
Plan is to use it using iNav. Having many motor outputs is GREAT

• Overall
• Quality
• Value

does the job

Mar 26, 2018

i had to flash the firmware to SPRACINGF3 from cleanflight 2.2 to get it to connect.

• Overall
• Quality
• Value

Faulty product, doesn't work. Bootloader unresponsive

Feb 05, 2017

Bootloader unresponsive, can't connect. Faulty product

• Overall
• Quality
• Value

Boot loader not responding

Jan 17, 2017

Board could not be flashed or connected in beta flight or cleanflight.

• Overall
• Quality
• Value

Boot loader not responding

Jan 17, 2017

Board would not connect to boot loader. Tried BetaFlight and CleanFlight could not be flashed or connected.

• Overall
• Quality
• Value

Beta Flight Boot loader Not Responding

Oct 31, 2016

Boot loader Not Responding in Beta Flight with my brand new board. I eventually managed to load the firmware but after cycling the power it stays locked in boot loader mode and that is without any jumper on the boot pins. It wont reload cleanflight and it is not even good for anything now.. Just once I would have liked to give a good review on something from HK. I had High hopes with this one, it had a nicely made board not as cheap and nasty as some, the finish looked good, pins are easy to solder because they are spaced apart well. I liked that it said betaflight compatible but then when you try to flash it the board wont flash without using another program.