FPV Transmitter & 1/3-inch CCD-camera PAL

Compatibel met de meeste 2.4Ghz video-ontvanger systemen is deze FPV camera en zender systeem is zeer veelzijdig en licht en zeer klein.
De camera maakt gebruik van een hoge kwaliteit glas lensed SONY CCD-camera-systeem.

In tegenstelling tot andere algemene systemen, hebben we een kabelboom geproduceerd en opgenomen met de camera, zodat de Tx en camera compatibel en op dezelfde spanning zijn.
Als u uw camera te kopen en Tx apart de stekker polariteit en spanningen kunnen zeer verschillend zijn.

Inbegrepen.
1 x Sony CCD 1 / 3inch Camera
1 x Voltage Regulator (input 3S batterij)
1 x Micro Light Weight Video Zender (100mW)

Camera spec.

CCD-sensor Type: 1/3 kleuren SONY CCD
Pixel;
PAL: 500 (H) * 582 (V) (meegeleverd)
Scanning systeem: interlaced scanning
Synchronisatie: Systeem: Inter
Horizontale resolutie: 420TV lijn
Minimale verlichting 0.01LUX / F1.2
DSP + CCD: CXD3142R + 405AK
S / N Ratio: 48dB
Gamma Wijziging: 0.45
Witbalans: Auto
Auto backlight compensatie: Auto
Lens: 3,6 mm
Audio: Geen
Ingangsspanning: 9 ~ 12.6V
Elektrische stroom 80MA
Elektronische sluiter: 1/50 (60) ~ 1 / 100,000s
Video-uitgang: 1,0 Vp-p composiet video
Operatie Temp .: -20 ~ 50
Maat: 38 * 38mm
Vliegtijd: Ongeveer 60min / 100mAh 3S

FPV Tx Spec.
Vermogen: 100mW
Voltage Regulator: 3S -> 5v

Zonder voltage regulator: 2 ~ 6V
Gewicht: 8g
Kanalen: 4

Gebruik: 1 3S LiPoly zal de camera aansluiten en via het voltage regulator zal het zendvermogen op 5v. U krijgt een 2.4Ghz video ontvangende eenheid nodig om het beeld te ontvangen. We zijn exclusief de 2,4 Ghz Rx-unit, want er zijn veel verschillende soorten en stijlen beschikbaar en bundelen ze samen zullen niet geschikt voor de meeste klanten.

Upload video

Registreer u om video's te uploaden aanmelden of registreren

Onderwerpen

Sorteer op

Meest recente onderwerpen

Plaats een nieuw onderwerp

Registreer u om beoordelingen te schrijven aanmelden of registreren

WazzaG | Geverifieerde koper

Overall
Quality
Value

Customer Rated

Jul 15, 2012

Haven't ranged tested this TX will do in 2 Weeks.
Caution check the polarity of the cable that plugs into the camera module before power up! My positive and signal wire were reversed, you can read it on the camera module. Tested at night worked a ton better than expected! Going to solder cloverleaf antenna to board and test range will document tutorial on my website www competefornothing com

Very impressed with this combo so far!

I am pretty sure these are the channels....
1 - 2410
2 - 2430
3 - 2450
4 - 2470

I have tested channel 1 with AIO 640x480 goggles sold here for $360

WazzaG | Geverifieerde koper

Overall
Quality
Value

Customer Rated

Jul 15, 2012

Haven't ranged tested this TX will do in 2 Weeks.
Caution check the polarity of the cable that plugs into the camera module before power up! My positive and signal wire were reversed, you can read it on the camera module. Tested at night worked a ton better than expected! Going to solder cloverleaf antenna to board and test range will document tutorial on my website www competefornothing com

Very impressed with this combo so far!

I am pretty sure these are the channels....
1 - 2410
2 - 2430
3 - 2450
4 - 2470

I have tested channel 1 with AIO 640x480 goggles sold here for $360

Klant | Geverifieerde koper

Overall
Quality
Value

Customer Rated

Jan 02, 2011

I just received the NTSC version of this.. I can't say I'm very impressed with the quality. It's not sharp at all. The colors are very weak. I have a standard Rx that has a tune dial. No problems getting a signal. I tried it in the garden to about 75 meters. My receiver was hooked to my main PC and I streamed the results to my laptop.. I ran out of laptop range before the camera went off. It was a bit crackly.. but I couldn't adjust the tuning, and the receiver was indoors, so not the best test. HobbyKing need to supply instructions. I have never had any instructions with anything I got from Hobbyking.

nordwest | Geverifieerde koper

Overall
Quality
Value

Customer Rated

Aug 10, 2010

As requested by many people - please find the usual 4 channel frequencies below:

CH1=2414MHz

CH2=2432MHz

CH3=2450MHz

CH4=2468MHz

Hope this helps -)

nordwest | Geverifieerde koper

Overall
Quality
Value

Customer Rated

Aug 10, 2010

Good video quality and TX is incredible small. Without jumper the TX transmits on channel 4 (2469 MHz). I use it with a common 4 channel USB RX on my netbook.

A connection kit for Eagletree OSD would be great -)

I can recommend this set!

nemo | Geverifieerde koper

Overall
Quality
Value

Certified Buyer Rated

Jul 25, 2010

Everything looks i'm still weighting for my receiver to test it, I had put it together to how it is set up it was easy but i don't know what the yellow, white and red wire are for.

Klant | Geverifieerde koper

Overall
Quality
Value

Customer Rated

Jul 25, 2010

I get only 4 stars due to lack of documintaion. great reange and decent cam for the little money I spent. works great with my FatShark Goggles.

Klant | Geverifieerde koper

Overall
Quality
Value

Customer Rated

Jul 07, 2010

Los canales del emisor se corresponden con los de la fat shark

Klant | Geverifieerde koper

Overall
Quality
Value

Customer Rated

Jul 01, 2010

here is a test http://www.youtube.com/watch?v=am8b1tFbkQA

Klant | Geverifieerde koper

Overall
Quality
Value

Customer Rated

Jun 15, 2010

A 500 m/watt 1.2 gig would be the best

900meg is used for cell phones so no good in SA and UK.

Upload bestand

Registreer om bestanden te uploaden.
Alstublieft aanmelden of registreren om nu hobbyisten te helpen!

Vliegtuigen

Helikopters

Drones

FPV

Auto's

Boten

Modelspoorbanen

Batterijen

Opladers

Batterijaccessoires

Accessoires voor oplader

Radio's

Servo's

Radio-accessoires

Servo-accessoires

Elektrische motoren

Gasmotoren / Glow-motoren

Machtsverdeling

Snelheidsregelaars

Gereedschap, tassen en opslag

Hardware

Accessoires

3D printen