HobbyKing 2.4Ghz 6Ch Tx & Rx V2 (Mode 2) (THROTTLE aan de linkerkant)Hobbykings T6A 2.4ghz-systeem is een instapmodel-zender die de betrouwbaarheid van de 2,4 GHz-signaal technologie en een ontvanger met 6 kanalen.Deze zender heeft een PC één van de kanalen variabelen, zoals mengen en servo omkeren wijzigen.Belangrijkste kenmerken;
6-kanaals 2,4 GHz zender met servo omkeren.
Gemakkelijk om de controle voor de basismodellen gebruiken.
Inclusief 6-kanaals ontvanger
Trainer systeem optie.
Dit systeem moet worden geprogrammeerd via PC-kabel.inclusief;
1 x 2.4Ghz zender
1 x 2.4Ghz ontvanger
1 x Bind Plug.Notitie:
Alleen HK-T6AM ontvanger Comptible met HK-T6AM zender.Alleen HK-T6Av2 ontvanger is compatibel met de HK-T6Av2 zender.
Gewicht ( g)
Let's begin with... it's a great radio for the price! The problem I have with it is that I will have to redo every boat I built so that all rudders turn the same way on every boat I have OR I will have to take the laptop to every event I go so that I would be able to reverse the servo's on those boats that have the rudder servo mounted differently... HK people it's not handy to have the reverse function as a setting in the programming..... it takes away a lot of flexibility!Kit was two years ago. Pritenzy and no comments. Everything works without comment. I would like to receive more information about the transmitter and receiver systems. During operation there were some questions. What type of transmitter? DSM2 or another. How to determine. I recommend to all beginners.Worst experience in RC Modeling. I have had this transmitter/receiver package almost a year now. Originally I used this stock out of the box. Behavior was so erratic that I bought the cable to adjust configuration. That was even worse. It now is so inconsistent that I pulled it from my quadcopter and I'm using another receiver with one of my quality transmitters. It's a pity, because I wanted this as an inexpensive way to build multirotors to give my kids, but it is so user-unfriendly that my kids would get nothing out of it but frustration. Price is great, but you get what you pay for.For the price this can not be beat. Feels great(although I don't have a bunch of experience) . My biggist complaint USD the reprogramming. But! I found a way around the crap cable.http://psychoul.com/electronics/how-to-make-your-own-usb-cable-for-hk-t6a-calibration. This is a site showing how to make your own that is way easier.
If you don't have ftdi to USB get one here on this site.http://www.hobbyking.com/hobbyking/store/__24779__FTDI_Adapter_USB_Controller_5V.html. then 4 jumpers and you are good to goNota 3 deve incluir o cabo e configurao simplificada, muito difcil adquirir o cabo fora do estoque e no tem suporte e nem ajudo para fazer a configurao no PC.My first radio, but the not the first one I've used; it's your basic, "get-the-job-done", 6-ch radio/receiver combo, and it does it well! I highly recommend getting the programming cable, and then downloading "DigitalRadio" to program it; it's a much better program than T6config, and worth every penny of the $2 for the full version! It even works on Linux (tested and working on Xubuntu 14.04LTS and should on any "buntu" or Debian disrto). Xubuntu recognized the device when I plugged it in. All I had to do was install Mono, to run the DigitalRadio software; and setup user access to USB/Serial devices, and read/write access for my user in the DigitalRadio director it saves config files to. I will post a "pick-whatever-flavor"-Buntu Linux how-to in the files section ASAP.Great controller, but this controller requires some big hands. This is a BIG controller.For a low cost radio this set is top. I think the single antenna may present a problem on distance but, i don't think it will show to much on the average application. The receiver is tight and small, good for smaller craft and it's lightweight, though the antenna is far from light. It is a great starter radio or for a younger person. (if they break it no big deal).Works awesome it's not the best but when you starting out you don't need all the fancy stuff thanks hkok, controller, HOWEVER !!!!! be AWARE you will need to purchase the "SPECIALIZED" USB PROGRAMER to set your Reverse switches and related functions! it is
NOT SOLD WITH CONTROLLER!!!
if Starting out? would HIGHLY RECOMMEND the FLYSKY FS-T6 bout $45.00 - $50.00
and can work with a VAST ARARY of Receivers !!! even the Reciver from the T6A !!!