Constant Current: 10A
Burst Current: 12A
Batterij: 2-3S LiPoly / 5-8s NiXX
BEC: 5 v / 1A
Motor Type: Sensorloze Brushless
Batterij Type: Lipo / NiXX
Brake: On / Off
Voltage Protection: Low / Mid / High
Bescherming mode: Verminder vermogen / Snijd de macht
Timing: Low / Mid / High
Startup: Snel / Normaal / Soft
PWM Frequentie: 8k / 16k
Helikopter-modus: Uit / 5sec / 15sec (Start delay)
Capaciteit ( mAh )
Gewicht ( g)
Excellent quality, lightweight design.Bonjour,
j'ai achet cet ESC parfait en utilisation indoor, poids 8gr sans connectique.
je le recommande. il fonctionne parfaitement. merci HKIn order to get this ESC to work with the Hobbyking minima RX, it was necessary to install a ON/OFF switch between the ESC signal line and the RX. Once the ESC had power applied to it, you can then turn the ESC signal line "ON" and it will work as advertised.This ESC works fine with other RX's but not with the Hobbyking Minima. (RX part # 236000010). See discussion thread for details.perfect ESC for 250 class quadcopter
flashed with simonk it can deliver precision and speed
nonetheless it's lightweight and have pads for easy flashing
i'm using it with Multistar Elite 2204 2300kvRunning strong on my quad with Multistar elite 2204-2300kv motors. Flashing was a pain though had to use the bare end wires from a 1.25 molex connector to make all 6 contacts and flash. I did get 4 of them done though, now loaded with bootloader so I can use afrousb. .All vehicles used in RC flying. It is also very light and can be programmed.!I use this esc for 2 month in an epp fun model with ~400g incl. battery.
Full load currency of my plane is about 12A an - but no problem for this esc.
One big adantage of this esc series is the "Reduced Power" mode with 3.3V/cell for voltage protection "High". This is a good protection for my liposSmall, lightweight. Using it for the Emax PM 1806 2300kv that calls for a 6-10amp EscPequeno e leve fonciona direitinho