Mini Fabrikator 3D-printer Door Tiny Boy - Orange - US 110V

• Overall
• Quality
• Value

Customer Rated

Oct 15, 2015

Great little printer! Shipping was very fast from Hong Kong; only 4 days to US. I have an Ultimaker 2 so I was a bit skeptical about the Fabrikator Mini. It arrived fully assembled and very well packed; no damage. I went through the setup in the manual. Only issue was the heated bed kept defaulting to "ON" and the print wouldn't start even though I was printing with a filament setting that sets the heated bed to zero. So I just changed the default filament settings and deleted my custom filament setting and everything worked fine. Printed some feet to raise the base for better air flow. First one printed fine. Then I got a terrible jam. I could not remove the filament. After disassembling the hot end I realized there was a burr in the heatsink preventing the bowden tube from being inserted fully. I cleaned up the burr by hand with a drill bit, reassembled everything, and it worked perfectly. Printed the rest of the feet and an octopus from Thingiverse. Print quality was very good with the default settings. The build volume is small but for the price it is the perfect for your first 3D printer.

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 08, 2015

I've had 8 days to play with mine so far. Only took 2 days to get here from HK. It's built pretty well but the tolerances on some parts could be better like the rail supports as they have a little slack. The screw for the y axis limit switch needs to lose the nut and possibly moved away from the switch by a mil to safely get the full 80mm. The X axis needs to be either set to 85mm instead of 80mm in the firmware to use the whole table and have it centered properly or set to 83 and move the switch closer to the outside of the machine a mil so its centered but not running the extruder right to the edge of the table on the other side. The z axis needs a notch on the top of the carriage corner so the wires for the limit switches don't get pinched on the last 2 mm of travel up top. The current limiters need to be set under the motor limits so people stop getting fried motors, mine were set a lot higher then the motors were rated for, and now work fine turned down although still hot. The extruder fan blows hot air all over the Y axis motor which explains why a lot of people lose y axis precision in the middle of long prints from it overheating so a better fan setup and/or y axis carriage arrangement is needed. The bottom of the machine needs to be vented with a fan and alot more passive vents to keep the 2 motors and board cool, i just printed the corner feet that are going around to have a big air gap on all sides and put a old pci slot fan underneath with the inlet facing up to b