Mini Mite Outrunner 1950kv voor 3D Park Flyer

• Overall
• Quality
• Value

Customer Rated

Mar 16, 2011

I'd recommend with the Dragonfly, although it seems a pricy motor (costs more than the plane) it works well, just adequate with a 5x5 tractor (turned around to make a pusher) Why are pushers so hard to get? Now with a 5x3 tractor .... you know the story. Pushes the dragonfly along well, without threatening to take the wings off, some more prop changes to make, perhaps 3 pack lipo (2 at the moment). But I would certainly buy another one.

• Overall
• Quality
• Value

Customer Rated

Aug 13, 2009

Did some flying:



500mah 3s, 10 amp turnigy Esc, 5x5 prop. Result my depron f14 can't make a left turn, the torque off the engine is just to much.



Did some right corner flights and the engine performed very good and is very fast indeed.



Tried it again with a 6x3 prop: result the same, torque is just to much.



So great engine, but no use in a depron pusher. Probapelly the bomb for any other plane that can counter the torque. 3 stars.

• Overall
• Quality
• Value

Customer Rated

Aug 12, 2009

Some simpel user feedback:



1. It is really precisoin made, the windings are superb.



2.The shaft is really short about 8mm, I had to trim it down so my propsaver would fit.



3.The 3 engine wires are not flush with the base plate.



4.It was overpacked in a shiny plastic container: including 4 mounting screws, a sticker and a instruction note



5. I will test fly it on a 8 oz depron f14 pusher. It's 80cm long and 50cm wide. More info soon