Quanum Power Distribution Board en Dual UBEC In One

• Overall
• Quality
• Value

Customer Rated

Jan 01, 2016

I've used 2 of these on 2 hexacopters with FPV!! It's awesome to distribute power to my 3S system (6 escs), to my FPV transmission system and it's awesome it has an adjustable 3V - 20V output that I used to power my 3.4V LED system with a switch (6 LEDS)!!. It's a must have product for Quads or Hexs. I really recommend it.

• Overall
• Quality
• Value

Customer Rated

Jun 17, 2015

Works great except my adjustable BEC appears to be stuck at 10V. Not really an issue for me as I have nothing that has to have 12V and it will all run fine from 10V, but could it would have been nice just in case. This is significantly bigger than the NAZE32 which isn't a problem for the quad I put it in (its huge and has heaps of space) but I'll be getting a smaller one next time.

• Overall
• Quality
• Value

Certified Buyer Rated

May 25, 2015

Eigentlich wirklich ein super Board fr einen 250er FPV Racer! Jedoch nervt mich das das Boti fr die BEC Spannung keine Anzeige hat, auch keinen Anschlag mit Min und Max. So ist es schwirig die Spannung einzustellen. Knnte man mit einem LED Strip machen um nicht was zu zerstren!

• Overall
• Quality
• Value

Customer Rated

Dec 02, 2014

This device is great. I put the 12V BEC on an O-scope and measured less than 25mV ripple on it. It gives a nice clean power source for my FPV gear. I highly recommend!

• Overall
• Quality
• Value

Customer Rated

Sep 01, 2014

Hi there, all things considered, this is a good solution to keeping one's wiring tidy and providing two clean power outputs. The board works very well stacked below the FC on standoffs. I measured the two outputs and found them both within spec. The build quality is good. The only negative was that the unit I tested was audibly noisy, in that it emitted a constant low frequency sound that could be heard from a few feet away.

To sum up I can recommend this unit as it does what it says it should. The price is a little high but I guess we all need to make money.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 22, 2014

Woks fine no more cbles anyware

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 17, 2014

I have no idea for power dist.... But good and cheap for ubec

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 28, 2014

Product is of decent quality and works as described. Haven't tested how clean the power is for video and transmission.

• Overall
• Quality
• Value

Customer Rated

Jul 20, 2014

Guys this PDB is legit. Power output is clean on ubec 1 and 2! Check out my FPV ground footage in discussion tab. I have 12v output plugged to my Tarot brushless gimbal and GoPro3plus plugged to 5V power output of gimbal control board. Higher voltages are stepped down to 12v or adjusted with the pot. Ubec 1 powers my FPV gear, Ubec 2 lights up my 12v LED's. 10 min flight not even warm. Very happy with this purchase and worth every penny IMO. I'm going to get another one soon :) Thanks Hobbyking!! Here's a link to the video . . . bit.ly/QuanumPDB