S3650-3300 borstelloze Inrunner 3300kv (15.5T)

• Overall
• Quality
• Value

Customer Rated

Jun 17, 2013

Comprei o motor, ele foi usado apenas duas cargas de bateria, digamos que algo entre 45 e 60 minutos, para minha surpresa, o rolamento frontal dele se desmontou, suas esferas foram atradas pelo m e prensadas contra os fios do enrolamento partindo vrios desses fios... Alem disso, apesar de ele indicar uma potencia de 750wts, perde feio em potencia para um clone dos EZ-run (3600Kv).
Vantagens: eixo 5mm, pinhes fceis de encontrar ( no Brasil) desvantagens: rolamento de qualidade duvidosa, potencia mediana.
S recomendo para on-road, onde dificilmente ter sujeira ou algo do tipo para detonar rolamentos, e em geral so modelos mais leves.
Ps.: montado em um DST/DBX convertido.

• Overall
• Quality
• Value

Certified Buyer Rated

Apr 11, 2013

Fantastic item. I use them all the time. In planes, in quadcopters, in cars, in boats - you name it. Nice durable motor.

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 22, 2013

Use this in my Tamiya DT-02 buggy. Drilled out sprocket to fit 5mm shaft. Very good power and good quality.

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 10, 2013

hammer motor,hammer preis

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 03, 2013

Espero que de certo em uma stampede!

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 23, 2012

Otimo produto! Recomendo a compra!

• Overall
• Quality
• Value

Customer Rated

Nov 14, 2012

This motor is amazing. I installed it on the stock Trooper and got excellent results. The model has become much faster. She started jumping even on a small hill, and under hard acceleration the front part off the ground. All this on the battery Lipo 3S. Of the small negative - the motor is heated to 50-60 degrees, but it may not affect anything.From ESC to 60A and more will be just fine.

• Overall
• Quality
• Value

Customer Rated

Aug 31, 2012

i,m planning too use this engine in a 70cm deep v hull with a 120a esc
And 2 5000 mah 2s 30c lipo's. Will this engine survive?

• Overall
• Quality
• Value

Customer Rated

Aug 28, 2012

UWAGA niskiej jakoi oyska naleao by je wymieni na dobrej jakoci , oyska zatary mi i po 30 minutach pracy

• Overall
• Quality
• Value

Customer Rated

Aug 02, 2012

I bought this motor to use on a 4wd hpi mt2. It is a 2 pole motor with a 5mm shaft and a low kv rating. Overall appearance is good. I used it with a 2s set up. With a 16t pinion the motor got warm. Speeds were around 28mph. I would only recommend this motor for someone that has a 2wd car and is looking for better speeds over a stock motor.