SBD4 4-kanaals S.BUS Decoder

• Overall
• Quality
• Value

Customer Rated

Sep 23, 2015

These work well with Futaba 8FG, programming card is a must to re-assign channels,
I mainly use these for wings, only 1 JR plug and then bolt on the wing. The wires are of good size and silicone coated for power transmission.Point to note use 6 volts and don't use thin extension leads or these have there own mini brown outs.
Excellent product - Takes Sbus signal and turns it into analog signal so you can use cheap/normal servos on the Sbus system

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 27, 2015

This S.Bus decoder works perfectly with non S.Bus Servos and it is very easy to use with the progamming card.

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 02, 2015

4 kanalen per kabel, onbeperkt uit te breiden

• Overall
• Quality
• Value

Customer Rated

Aug 05, 2013

This works perfectly with the Futaba R7008SB. You don't have to plug it into the rx to program it, just a 4.8v battery in the slot marked for the Sbus rx and then press the buttons. It actually gives the ability to program DG1 and DG2 channels plus the normal 16 which makes it better than the Futaba original!! Very impressed all round and the soldering is of a high standard so should be reliable.

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 06, 2013

great item, with T8fg Futaba and R6208SB you can setup it as you want. mooore cheap than original futaba decoder! thank yoi hk!

• Overall
• Quality
• Value

Customer Rated

Nov 29, 2012

The S-Bus decoders work fantastic!

I did just built a Lunak 1:2.5 in full RFG with 5.8 m wingspan. The Lunak has 5 Servos in each wing (14 servos in total) The S-Bus decoders were programmed and then installed in each wing. So I have only one cable coming out of each wing!!!!
And yes, the decoders also work with the Futaba RX's e.g the new R6308SBT for FASST telemetry.

So five stars for these decoders!

Juergen