Turnigy Aerodrive SK3 - 4250-410kv borstelloze Outrunner Motor

• Overall
• Quality
• Value

motor

Mar 12, 2022

Good service as usual, good quality, shipping time ok

• Overall
• Quality
• Value

Great!

Oct 22, 2021

Well-assorted and qualitatively appealing accessories and special small parts offered comparatively cheaply - great!

• Overall
• Quality
• Value

Top

Sep 16, 2021

Top

• Overall
• Quality
• Value

Fair Prices

Jul 16, 2021

HK where I like to shop because I buy at fair prices.

• Overall
• Quality
• Value

It works

Jun 05, 2021

It works and is what I expected it to be.

• Overall
• Quality
• Value

Nice Product

May 29, 2021

Nicely made, quality product, recommended.

• Overall
• Quality
• Value

Buy recommendation

May 03, 2021

Very happy with the performance and the price is good too!
For long flight times with low load I use 12x8, for efficient load 13x8, for medium to heavy loads 14x8 and 14x10, for maximum load in continuous operation with good cooling I use 15x10 without any problems. 16x8, on the other hand, is not suitable as the motor can then overheat.

• Overall
• Quality
• Value

Prop adaptor poor quality

Mar 17, 2021

The motor operates as it should. However the alloy prop adaptor is badly designed. It is small diameter alloy with a hollow shaft. It’s only a matter of time before it snaps. In true HobbyKing style, parts are not available and the “notify me” request sits in limbo today. Without the prop adaptor, the motor is useless.

• Overall
• Quality
• Value

It's okay

Jan 29, 2021

It's okay.

• Overall
• Quality
• Value

Smooth running motor - eventually

Jan 25, 2021

This motor was bought to power a 4m scale glider in FES mode. To accommodate a collet drive for a folding prop, the shaft had to be reversed - a collar is provide with the motor to enable this to take place. To remove the shaft the set screws have to be remove and the circlip, at the back of the motor removed ( the circlip is not needed again but the brass washer needs to be retained).
The set screws are glued in and are impossible to loosen with an Allen key. The trick is to apply a few seconds of heat, from a pin-point blowtorch flame to the setscrews (one at a time), protecting the motor with a thick, wet cloth. The screws then easily release and the shaft can be removed and reversed in the normal way.
The motor is now installed in the model, with a Plush 60 ESC, 6S lipo and a 14x7 Cam carbon folding prop. Current draw is about 35 amps giving 700+ watts - well within the motor's spec.