Turnigy Multistar 10 Amp Multi-rotor borstelloze ESC 2-3S

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 27, 2014

So tiny and lightweight and perfect! Already ready to go with 2mm connectors on all the wires. At this price its a no brainer.. Perfect for my 250!

• Overall
• Quality
• Value

Customer Rated

Jul 22, 2014

Don't bother with these they don't perform well at all. and can not be flashed with socket tool as atmega chip is to small very small. wast of money get some Simon k instead I'm very disappointed with these want my money back their useless for multi rotors!!!!!!

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 06, 2014

Mis avec turnigy multistar 1704 pas de surchauffe bon vario

• Overall
• Quality
• Value

Customer Rated

Jun 09, 2014

Bought these for my 250 mini quad with multistar 1704 motors and mini APM flight controller. I did also got the program card and set them up best i can. Even on NIxx on lowest setting my battery alarm goes off and they are already cutting the power to the motors. I am gonna try the HK f10a flashed with simonk next as these will eventually lead to a bad crash. Also the overload cut off is annoying because if you touch back down one or more motors will quit and you have to disarm and rearm. I am not sure why they engineered these the way they did since basically they are not good for multirotors at all??

• Overall
• Quality
• Value

Customer Rated

May 15, 2014

Good esc(s) placed in my 330 frame with a KK2.1 board flashed with 1.11 firmware, 3s 1000mah Zippy compact batt, Turnigy 10amp Multistar esc(s) 8ch 9x receiver, power board soldered the esc direct to it and XT60 batt plug on it, 8045 props, this thing it a rocket and getting 6 minutes flight time. After flight everything is cool. Will hoover with only 40pcnt throttle. Motors are Turnigy D2822/17 1100 kv. I did soldered 3.5 bullet ends on everything.

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 10, 2014

No better than any non flashed esc for multirotors, after flashing with simonk they are 10x better, but this is not easy as there are no pads and the hk flashing tool is too big for the atmega chip on this esc, so you have to solder directly to the chips pin outs. For this reason I would not buy anymore as there are others available that are far easier to flash. If they are specifically for multirotors why does it have brake settings, set to medium as default lol.

They also have no throttle calibration, they are auto like dji escs, but you get throttle calibration when flashed.

• Overall
• Quality
• Value

Customer Rated

Feb 23, 2014

i've got a few brands of 10amps this is the one which fits me the best especially compared to the piece of crap red brick also from here...

• Overall
• Quality
• Value

Customer Rated

Feb 18, 2014

Really cool ESC for mini quadcopter. I use them with Turnigy Multistar 1704-1900K, kk2.1. And works well. I calibrated them straight kk board.

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 07, 2014

nice little ESC. Runs without flashing to SimonK also good enough for smaller Multicopter.

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 06, 2014

Works ok, but gets hot faster than eg. the tgy plush esc. Bought a bunch for a small quad and put another on a bonsai flying wing. Dont forget to get the programming card too!