De Turnigy Smart LED-systeem stelt u in staat om niet alleen te configureren van de meegeleverde LED's voor een grote verscheidenheid aan ander licht zetten's, maar kunt u ook de lichten via uw gaspedaal en de stuurinrichting servo controle! Alles wat je nodig hebt om deze prachtige LED Lighting System geïnstalleerd is inbegrepen.
1 x System Control Box
4 x 3mm Gele LED w / wire
4 x 5mm witte LED w / Wire
2 x 5mm rode LED w / Wire
2 x 5 mm blauwe LED w / Wire
Dubbelzijdig Self Adhesive Pads
Zelf Adhesive Cable Tidy's
2.4ghz PPM / FM / FS Compatible
Operating Voltage 4.8V ~ 6V
Gewicht ( g)
The Lightning System is very easy to connect and to setup. All LEDs works and the lightness of the LEDs is good. I buy it in the EU Warehouse and it comes in 3 days. All functions are easy to set them up. It works fine so i have buyed 2 more from this Kit. I can only recommend the product.Very cool light set! I put on my sabertooth and every time I turn the signal turns on, and when I stop the break lights turn on! Super fun mod for any vehicle!I just installed this on my RC Drift Car and had to remove the turn signals. With the turn signals connected all the lights would go crazy and not respond correctly. Like it's not a big deal since the rest works and you can't complain on the price.super mont sur un scale juste une chose les fils sont un petit peu trop court
facile a connect mais pas de schema de branchementworked fine for a second then shorted my ESC and motor, cheap quality unit not much to the units main box. would advise against installing in a expensive rc car or plane. buy the higher spec led system version.Great system led and at a great price!Turn signals works perfect, stop light and backlight it's not what I expect.
In deafult connection:
When car is standing backlight it on, when car starts all lights (back) are off.
When car stops then stop light lighting and it's ok.
But on revers drive stop light is still lighting.
Yoy can change cables then reverse light is lighting in revers drive and stop light when car is standing, but when you stop car ( press breake) than stop light isnt on.
Sorry for my english :)
I have instaled this Lighting system to my HIMOTO ZENIT XT.
Everything works as manufacturer says, but the problem for me is, that all lights are permanently switching on and off when the car stops, drives, turns, breaks etc.
There are no permanent front neither back ligthts!the lights sequence can be pretty messed up. my left orange signal doesn't correspond. It's lighted instead during hard acceleration. I'm think is another 1 or 2 inappropriate lighting sequences. but as it is not expensive and posses no danger, i'll keep it.
Will i recommend it?...... i suggest you shop around :)I bought two of this and apart from the really bad Chinglish instruction, which didn't match the port lable on the actual unit, I like the result. If you are going to buy one, just make sure that you follow the instructions on the manual.
It has four white light for the front, two red light for the back (to indicate braking), two blue light at the back (to indicate a complete stop) and 4 yellow light for indicators.
I got my brother to install it and he thought the brake lights was not working so I told him to make sure that his channel two exponential is at 100pcnt and got it working as expected.