Turnigy ™ TGY-213C Metal Cased 250 Helicopter Cyclische Servo 3kg / 0.07sec / 16g

• Overall
• Quality
• Value

trex 250 DFC Cyclic

Dec 03, 2016

Still using these servos and working great!!

My heli had a hard landing a few weeks ago, stripped maingear during a flip and landed hard on the skids, breaking the landing skids and bouncing onto its side.

Heli broke a ball link on the DFC arm but everything else survived. Probably not that much of a crash more of a controlled emergency landing but the servos are still working.

have done probably 30 flips on them and no problems.

This is on a copterx 250 which has been upgraded to align DFC (only remaining copterx parts are frame esc and motor)

Highly recomend these servos. Just note that you have to take the back case of so you can get it into the frame as the cable strain relieve gets in the way.

• Overall
• Quality
• Value

trex 250 DFC

Nov 09, 2016

I had been struggling for quite a while with my copterx250 (which is now mostly align and has the DFC head) until i changed to these servos.

These are not a straight fit however on the 250 as the cable strain relief stops them from sliding inside the frame. Not a problem though, just remove the 4 screws on the back of the servo and take of the back cover fit the servos and refit back cover and servos.

These servos look to be really high quality, really strong, centre very well and plenty fast for cyclic. First flight since fitting was a big difference to the cheap anologues i had on.

You can see them in use (aswell as a turnigy 306 HV on the tail) here

https://www.youtube.com/watch?v=gBJW0MAuS20