Turnigy TGY-A55H ontworpen voor F3A low profile prestaties, betere precisie beweging en lage elektrische impedantie. Deze low profile servo is ook een goede keuze voor intrekken vistuig, alsook dunne vleugel rolroeren.
Full Metal gear
Volledige Alloy Case
3-Pole Metal Brushed Motor
Dual Ball Bearing
Gewicht: 28,4 g +/- 1g
Afmetingen: 30,00 x 10,00 x 34.50mm
Koppel bij 4.8V: 7.0kg / cm
Koppel bij 6.0V: 8.6kg / cm
Snelheid Bij 4.8V: 0.15 sec / 60 ° onbelast
Snelheid Bij 6.0V: 0.12 sec / 60 ° onbelast
Gewicht ( g)
Snelheid ( Sec / 60deg )
Torque ( kg) ( min . 0,01 kg )
Unit Weight (g):
A ( mm ):
B ( mm )
C ( mm )
D ( mm ):
E ( mm ):
F ( mm )
THE WING FLAPS ON MY THERMAL GLIDER (VULTURE) ARE BIG SO I HAVE FITTED THESE AND THEY WORK VERY WELL-HIGHLY RECOMMENDED 5STAR.I bought 6 of these for a glider (2 * ailerons, 2 * airbrakes, rudder, elevator). Two have failed, fortunately in testing and not in flight. They were supplied with regulated 5.9V using a Powerbox Sensor. I will endurance test the others using a Hitec servo tester but have bought 3 MKS DS6125 as replacements for elevator and aileron control.These are a quality servo. Good power, centre well and they are not very noisy. They use a Futaba spline. I'm using them as aileron servos in 90 - 120 size electric aerobatic aircraft, also for flaps on 2.5m and 3.5m composite gliders. No failures to date. I'd recommend them.Super Flchenservo,
habe es in der Sea Hawk 120 EDF. Sehr zuverlssig. Stark und preiswert.I have fitted 2 off these in my MVM Vulture glider and find them very able to operate the huge flaps on this model using the supplied metal horn cut back one hole, they are fast with no backlash! Highly recommended, I'll use these again!!!I received 4 servos for my new 4m sailplane Valenta ASW20. I did a quick test on the servo tester and they worked flawlesly. Will report back.After 2 flights mounted in a gliger wing both are broken !
Both were sent in to HK 2 months ago w/o any reaction !
So only lost of money ;-(
Also with other TNY servos i had the same problem broken, sent in but no reaction ! So i will never buy servos again from here.
. . . . &I ordered and received 4 of those servo.
Opened and tested, they are perfect for my new glider, a DG 1000 6 meter wingspan.
Thanks' a lot HK for those perfect product !!!
Best regardsI use 9 of this on a 6 meter full CFK glider. Voltage regulator is set on 6v., servo have fast answer and no delay. This metal case is perfect to be fitted inside thin wing.