2-Axis Camera Brushless Gimbal Estabilização Control Board w / IMU

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 08, 2016

muy buen estabilizador, cuesto mucho echarlo a andar no es sencillo, se requiere paciencia y conocimientos previos del hobby, una vez configurado funciona perfectamente. Las entradas de pitch o roll que binen en el circuito impreso no sirven, hay que conectar los cables en las entradas A1 y A2 del circuito impreso.

• Overall
• Quality
• Value

Customer Rated

Jul 04, 2016

Total waist of money & a lot of time!!!!!! Just don`t buy this board, you`ll spend hours trying to make it work until you just put it to garbage!!!!! if it works, why don`t they install a basic firmware before selling???
Hey HK, you forgot to put zero crown in your list...

• Overall
• Quality
• Value

Customer Rated

Jun 17, 2016

Not easy to get this board going for a newbie...
None of the files on this site easy to follow, not even a file with the same board...
I have the usbasp adapter I previously used to flash a KK board, but no info for connection available.
Should have bought a rtr board instead....

• Overall
• Quality
• Value

Customer Rated

Dec 25, 2015

The board itself is fine. It works for the most part really well. The software is a whole nother story. Just do yourself a favor and get the USBAVR programmer and flash it with nulled. It will save you some stress.

• Overall
• Quality
• Value

Customer Rated

Aug 19, 2015

lost money and time if you buy this control
"" mission impossible '''
:)
to set up this control

• Overall
• Quality
• Value

Customer Rated

Jul 26, 2015

I have spent countless hours trying to 'tune' this controller. It is an utter nightmare. The so called documentation on the wiki is very very poor. I don't recommend this. It is ridiculously hard to setup. I still have not achieved a working setup.

• Overall
• Quality
• Value

Customer Rated

May 05, 2015

Works perfectly. Flashed SimpleBGC firmware via USB. Soldered pitch cable to control pitch from reciever. Works brilliantly with 2208 motor gimbal.

• Overall
• Quality
• Value

Customer Rated

Mar 28, 2015

Perfect product, I love it, it was not easy to setup, but with latest firmware 51, and correct setup with brugi sw and a very low P (PID) now it works perfect with my cheap HK Carbon Gimbal and my Gopro Hero 3.

• Overall
• Quality
• Value

Customer Rated

Jan 28, 2015

I received the V2 version NOT the V3 as advertised here.
Older product and more troublesome to update/configure
it will probably work i guess, still have to test it.
Beware!

• Overall
• Quality
• Value

Customer Rated

Jan 18, 2015

You will receive aBGC 2.2 Brushless Camera Gimbal AIO Controller alexmos V2.2 Firmware w/ Sensor Voltage Step-Down Module which cheap clone