5.8Ghz transmissor 200mW.
Bom para até 500m voando com a antena fornecida. Uma antena direcional opcional pode aumentar o alcance de 1km +
Inclui microfone embutido.
Receptor tem saídas AV adicionais para gravação de vídeo enquanto estiver usando óculos FPV.
impedância de saída: 50Ohm
Potência de saída: 21 ~ 23dBm
frequência do canal 1 ~ 8: 5705/5685/5665/5645/5885/5905/5925 / 5945mhz.
tensão de operação do transmissor: 7 ~ 15VDC / 150mA
tensão de operação do receptor: 5VDC
Temperatura de operação: -10 ~ 85 ° C
largura de banda de vídeo: 0 ~ 8,0 MHz
freqüência de áudio: 6.5MHz
Nível de entrada de vídeo: 0,8 ~ 1.2Vp-p
Vídeo impedância de entrada: 75Ohm
Áudio nível de entrada: 0,5 ~ 2.0Vp-p
Áudio impedância de entrada: 10K / Ohm
Peso: 25 g
conector de antena: SMA
Características do Produto
Capacidade ( mAh)
Peso ( g )
Note that the connectors are rp-sma, not sma! Have a lot of incompatible connectors, will have to order a new batch...http://fpv-community.com/testblog/2010/bevrc-5g8-200mw-fpv/
here is an test for this. Im happy good range and vid. kvalityRanges from ~ 900 meters are possible, one or another test to follow even more than 1000 meters.
The built-in microphone I feel themselves to be too low, and the suppression could be a little better, but still well done.
Several dealers offer the same receiver for ~ $ 35. There are two versions, the 12 volt version, and a 5 volt version. This offered here is the 5 volt version. In addition, some give the manufacturer / tester at different frequency channels, but these are all the same. Probably just a typo or just bad data via drag and drop added.
Ordered 2 of these. One arrived with a damaged paperbox and a broken coil on the transmitter, unit was dead on arrival.
The 2nd unit works great, good video quality and good range for FPV flying.
Use servo wiring to plug a 12V camera to the transmitter, allows easy connection. Great system!Hello, I received this item and camera SONY CCD.Can you tell me if the camera 1/3-inch SONY CCD Video Camera (PAL)is apropiate for this item?. I only can see a gray image on TV.
Where is appropriate connector or connection draw?Es una pena que no coincidan las canales de video, con las gafas fast Shark, solo se puede usar con su propio receptor.This is the set for you if you are running 2.4ghz control and none of the lower frequencies are legal in your country. Not only that, but it is good to keep the video frequency higher than the control frequency, so that you will get a 'warning' of flying out of LOS before your control failsafe kicks in. It's easier to fly through a fuzzy video than to go walkies for a model that flew out of 2.4 line of sight.
Stock this setup is good for 500m range, with a nice patch it has been tested to 1.5km. Long range isn't everything. For Aerial photography downlink it is ideal, since this is not a long range exercise.Very good transmitter and receiver, but 500mw would be better.
Antenna connector come loose, add heat shrink sleeve at the base of the antenna and they are ok. Good for visual range distance, not long range flight.
I use it to retransmit the video from my Antenna base mount on tripod. I transmit from the plane to the tripod at 900mhz and retransmit from the tripod to my headset at 5.8Ghz. No more cable between the tripod and my headset.
Finally the 5.8 GHz FPV system has arrived at HobbyKing!
Will rate it 5-***** but not going to buy It, because 200 mw not enough for meh.
Will wait for 1000+ mw and some HD cameras/goggles with the awesome results are guaranteed.
Cheers anyway HK \o/
Somente usuários registrados podem fazer o upload de arquivos. Por favor Registre-se para que você possa começar a ajudar seus colegas de hobby hoje ainda!