Ferramenta de Programação USB Afro ESC

• Overall
• Quality
• Value

Remove heatshrink!

May 13, 2018

Like Lyle said, you need to cut the heat shrink off - at least from the USB connector part. Otherwise it won't go deep enough into computer's USB socket and is not connected. Bad design, but otherwise working component. It is using CP201x drivers from Silabs website.

• Overall
• Quality
• Value

Good tool but...

Nov 23, 2016

Mine would not connect until...I cut about 1/4 inch off the heat shrink that fits over the USB connector. The heat shrink prevented the USB plug from fitting properly into the USB socket on the computer. After the little mod everything worked fine.
Lyle.

• Overall
• Quality
• Value

Good tool but...

Nov 23, 2016

Mine would not connect until...I cut about 1/4 inch off the heat shrink that fits over the USB connector. The heat shrink prevented the USB plug from fitting properly into the USB socket on the computer. After the little mod everything worked fine.
Lyle.

• Overall
• Quality
• Value

Tool won't fit

Nov 23, 2016

Beware...mine would not connect until....I cut back the heat shrink over the USB connecter.
The heat shrink was too long to allow the USB plug to fit into the USB socket on the computer.
Everything worked fine after the little mod.

Lyle

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 04, 2016

Probably good but i cant use it. I have follow all the steps i have found on tab "files" but i dont know where to find the firmware. Probably veru good material but veyr poor literature.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 14, 2016

tiny but very important. if you have afro esc this is recommended to have latest flash on you esc

• Overall
• Quality
• Value

Customer Rated

Jul 07, 2016

Very simple and easy to use tool that works well. Its very cheap and works flawlessly with the afro esc's. I have used them on the 20a slim and 30a without any problems. I think they should work with any esc that has a simonk bootloader, but I have not tested to verify this. This is a little simpler than using an arduino as ISP to program an esc, and especially so if you do not directly solder the esc so you can still use the servo leads to plug directly into the programmer.

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 05, 2016

I could used with Blheli.

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 09, 2016

have not been able to get to using it yet, but hardware seems decent enough

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 07, 2016

Top Produkt, easy to programm ATMEL ESCs