Arkbird 433MHz 10 canais FHSS UHF Módulo / Repeater Station com receptor

• Overall
• Quality
• Value

Customer Rated

Aug 01, 2016

I achieved 20.15km but with hand made moxon antenna and again handmade dipole receiver antenna... With stock antennas it would be max 6km around.

• Overall
• Quality
• Value

Customer Rated

Jul 30, 2015

I use mine on 2 m high tripod. We fly two FPV planes simultaneously and so far so good with the side by side operation (no interference with each other) during FPV "formation" flying. They both work as relay units from 2.4 GHz receivers. Using an aluminum foil roasting pan with a hole in it sandwiched between antenna base and top of unit to act as an antenna ground base and prevent any interference with the 2.4 GHz system. Range with Arkbird receiver on plane, with no foil X under it (as suggested in manual) is about 5 km. With foil X it is significantly more but I run out of video range before control range. Overall unit works as advertised, control is smooth with no discernible lag. I am happy with the cost vs quality of these units.

• Overall
• Quality
• Value

Customer Rated

Feb 09, 2015

I bought and tested it many times. I can say that maksimum limit you can achieve with this product is 6.200mt. Never hope more then this.

• Overall
• Quality
• Value

Customer Rated

Jan 26, 2015

I tasted it 5.500mt without any problem. RSSI was showing pcnt50 and the weather a little foggy. Also I supplied by 7.4V instead of 12V.
I guess its possible to achieve up to 10.000mt in good weather conditions and 12V supply.
Its very easy to set up but you have to discover it by yourself. There are almost no instructions.
I will attach a video soon to prevent people to be crazy while trying to find how to set it up.

• Overall
• Quality
• Value

Customer Rated

Jul 18, 2014

Got he arkbird working in repeater mode on the turnigy 9x after 2 days of struggling.
The system is very simple and works very well but the instructions SUCK.

I have only flown out to 3,5 km without any problems( that is the max range of my video system.

If you cant get the system to bind, after the receiver is flashing fast, unplug the battery from the repeater and plug back in (reset the repeater) this will complete the bind process.

• Overall
• Quality
• Value

Customer Rated

Jun 23, 2014

Got mine yesterday, just getting it set up. Instructions are of course poor. So, you should have an understanding of what you are doing. It appears to be a nice piece, the only reason I didnt give it a 5 on quality is, mine came with a couple bent pins. I had to take it apart and straighten them. Also, not enough room to actually plug in the wire loom, had to grind the case down some. Outside of that, it appears to be quite awsome.

• Overall
• Quality
• Value

Customer Rated

May 30, 2014

test it the first time today with hitec aurora 9.
very important for hitec users.
you have to move the black wire in the transmitter connector to the third hole
( it's on the fourth one ) otherwise it will never work ( you will get no output from the transmitter).
I shall write more after flying.
ilan