Seta 4,3g / 0,8 kg / 12sec Servo Micro

• Overall
• Quality
• Value

Pretty good

Apr 07, 2019

for a cheap servo. Shaft slop is excessive on most but I don't use them for precision. I've had 6 and they all still work fine.

• Overall
• Quality
• Value

Good servo

Jan 19, 2018

I was surprised with how good these servo's are. Reliable, fast , light and very good value.

• Overall
• Quality
• Value

Great little servo

Dec 23, 2017

I was very pleasantly surprised with these little servo's. They work very well.

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 20, 2016

mad little survos do what you want nice and smoothe and quick

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 22, 2015

petit servos efficace en indoor.

subit du 3D extreme pendant une saison sans probleme plus cela devient difficile...

je le recommande

• Overall
• Quality
• Value

Customer Rated

Jul 17, 2015

I bought 2 of these to try. Firstly they are fitted with a normal JR plug and wiring is normal.
I changed my plugs as I have a PA-09 Crimper and lots of patience. There are however adapters available if you use a FrSky VD5M Rx like I do.
Initially I put them on my servo cycler as I like to run them for 10 minutes or so before I install them. I a bit was worried as they were very jittery even on different ms settings. However when I plugged into my FrSky Rx they were very quiet and no problems at all.
They are also the first servos I have ever had that get quite hot and very quickly. I was running them at 4.8 volts. They seemed quite OK but I wouldn't fit them in anything that required some duration.
I would not buy any more of these as there are better ones available but they will suit my intended purpose at this time.

• Overall
• Quality
• Value

Customer Rated

Feb 12, 2015

I put this little servo in an rc car that i converted from cheapie 35mhz controls to a proper rc drifter. This little servo has taken so many impacts with the wheel jamming hard over as a drive shaft popped out and yet it's still fine. Not one stripped tooth. Really an impressive servo to say the least and I would certainly buy it again for small foamies or whatever I can hack together next.

• Overall
• Quality
• Value

Customer Rated

Jul 18, 2014

j'en ai pris 6

je les utilise dans des parflyer cap232 et sukhoi 26

super permomant

rapport qualit prix imbattable

vous hestitez encore ? pas la peine foncez

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 28, 2014

Small but tough servo.

• Overall
• Quality
• Value

Customer Rated

Dec 28, 2013

Just received 3 of these servos and checked them via my servo checker. They run smoothly and quietly, however, the centering is erratic. Basically, when at full throw either side, and you go back to neutral on the servo tester, the servo rotates back toward center but stops past center clockwise. Then over the next 10-15 seconds the servo 'steps' back toward neutral in 4-5 separate steps finally stopping near neutral. So, from my viewpoint, not usable in any situation where you are expecting reasonable centering.

Don