FPV Corrida Drone PDB com OSD BEC para CC3D

• Overall
• Quality
• Value

recommended.

Nov 07, 2016

very nice that there is a micro USB on
With a capacitor extre no image loss.
no noise from the bec.
recommended.

• Overall
• Quality
• Value

recommended.

Nov 07, 2016

very nice that there is a micro USB on
With a capacitor extre no image loss.
no noise from the bec.
recommended.

• Overall
• Quality
• Value

Customer Rated

Sep 27, 2016

I received the board fairly well packaged and flashed it with the latest MWOSD firmware as per specification. The board was flashed successfully, as well as programmed. Then it worked ok-ish for a couple of times. OK-ish, because the fonts were not displayed properly, but that might be the firmware's fault, not the board's.
Anyway, what seemed stupid, and yes it's a strong statement, but that's just hoew it is, because if you look at the first picture at the left hand side corner of the board, you'll she a tiny tiny component soldered very very close to the mounting hole. When you screw the standoff for the FC chances are you'll knock that component of it's pads. So really not very well thought layout. Other than that could be a fine board.

• Overall
• Quality
• Value

Customer Rated

Sep 23, 2016

This is basically a very good product and an excellent value, but I must give it a low rating because of a build quality issue. The chip that does the OSD video overlay wasn't fully soldered to the board. Most of the chip's pins weren't soldered at all, resulting in a very flaky video signal (which I originally blamed on my video transmitter/receiver pair). I was able to fix the unit by soldering the missing connections under a microscope, but that's far beyond typical hobbyist capabilities. Most folks would have to return the product at their own expense, or worse, would suffer an in-flight failure. Examine the unit under a magnifier before installing it!

Once all the parts were properly soldered and the board was cleaned and dried (dish soap, hot water, and a toothbrush, followed by blow-off with dry air), the unit works well. I'm using the Minoposd firmware with LibrePilot loaded on the HK CC3D Mini.