Goteck BL1511S Digital Brushless MG High Torque Low Profile Car Servo 45g / 12 kg / 0.07sec

• Overall
• Quality
• Value

servo

Aug 23, 2019

the servos ar ok, I use them in HK-600 without Problem.

• Overall
• Quality
• Value

Good product for the money

Apr 08, 2019

I have built the servo into my TA-05 and am thrilled by the speed and precision. A bargain for the money. From me there's a recommendation to buy.

• Overall
• Quality
• Value

Customer Rated

Nov 07, 2015

Good quality servo. Use it as a retract servo for my Hyperion Hayate 40e size plane. Setup burnt a lower end servo previously. This servo handles the load well. But it got pretty hot. Hope it holds for maiden.

• Overall
• Quality
• Value

Customer Rated

Oct 28, 2015

I ordered only one servo and tested in terms of speed. It is very good! My only problem is that the servo horn simply did not fit! It was impossible to assemble! Any other servo horn was ok except the included one... Have you met this problem? Strange that the product picture also shows unfinished inner part of the horn...

• Overall
• Quality
• Value

Certified Buyer Rated

May 15, 2015

Ottimo servocomando molto veloce 0,07 secondi e potente 12 Kg considerando che si tratta di un servocomando a basso profilo. inoltre estremamente leggero 45 gr ingranaggi in metallo e cassa mista plastica metallo. ottimo rapporto qualit prezzo pu essere tranquillamente paragonato a servocomandi di prezzo decisamente superiore. consigliatissimo.

• Overall
• Quality
• Value

Customer Rated

Feb 03, 2015

I use this servo on my trooper and it works great, fast. I opened the bottom plate to make sure it has seal or not and yes it has rubber seal on the bottom plate and also on the screws. So I think this servo is also waterproofed.

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 26, 2015

Centering problem. Good price for a brushless

• Overall
• Quality
• Value

Customer Rated

Jan 22, 2015

I got three of these to try out. 1 for my Xray X1 and 2 for my NT1. I installed the F1 servo and it was TERRIBLE. It was non responsive to sub trim adjustments and would jump to position after 30 or so sub trim steps. Then once on track it would never return to the same center position. This caused the car to wonder aimlessly. I didn't even bother opening the other 2 servos up. I'm returning all. Of course I could have just got a bad one to start off with but it's just not worth the trouble. Much better / proven servo for just a bit more money on the market.

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 24, 2014

Very responsive servo. I have 2, using one for steering in my electric 1/10th tourer and throttle/brakes servo on 1/10th nitro tourer.

Current draw is quite high. It causes 3 times the voltage droop compared to the full size KO Propo steering servo in the same model.

Still great value for the money.