Este dispositivo permite que você com segurança e remotamente matar a sua ignição do motor eletrônico equipado com seu transmissor.
Tensão de entrada: 6 ~ 12v
Corrente de entrada (max): 6A
Nota: Um manual está disponível sob a guia Arquivos
Características do Produto
Peso ( g )
I've just found that my switch will only kill the motor if I switch it on before my receiver is switched on. The motor will run all right. It just won't kill the motor. I don't know if every switch is the same, but just something to try if your's isn't working correctly. Works all right on a 4.8v 4cell flight pack.Used to make kill switches using an Arduino board. But at this price I can not manufacture it myselfComponente essenziale per staccare la corrente sui motori benzina,ottimo prodottoG'day Got one before and it didn't work below 6V, Ran a regulator after the switch and job done. I got another one and hooked it up. Lights came on and wouldn't turn off. So I dived into the reviews here and found that the input/output wires were reversed on the board, confirmed by swapping I/O with a couple of adaptor leads. Resoldered the leads and bingo, works well now.Ordered two of these and they arrived today. Mine arrived with the in and out connectors soldered in the correct sense i.e. the input has a socket on it to accept the plug on the battery pack and the output has a plug on it. They also work correctly down to 3.6 volts on the load power supply so the ones I have will work as a ignition on/off switch when using a 4.8 volt pack to power the ignition on a gas engine. The fail safe works in that it will cut the power to the engine ignition box if the Tx /Rx link fails. Top marks HobbyKing!!!!Ideal en caso de que se rompa el mando de acelerador, o se trabe el carburador, o el ralenti del mtoor sea tan bajo que no se pueda plantar. Esto corta la chispa del cdi y apaga el mtoor. RECOMENDABLEDoes the job perfectlyVery good, no problems with interference, using with a dle 20cc, good to kill engine right before landingGreat little item, to be used on my 30,5ccm BajaVery nice little unit, does exactly what it says it will. Note 6v is NOT required. It works fine with 4.8v on both sides.