Conversor de sinal Módulo SBUS-PPM-PWM (S2PW)

• Overall
• Quality
• Value

tut, was es soll

Feb 07, 2021

gutes Preis Leistungsverhältniss

• Overall
• Quality
• Value

Great product

Oct 06, 2020

Exactly what I needed, cut down on wiring and great price. Works perfectly.

• Overall
• Quality
• Value

S2PW works very well

Dec 09, 2019

I wondered if it would work, but I can say 100% that it does. Saved me buying a PPM or Sbus tx/rx, highly recommended. I use my Turnigy with this and you would never know there was a converter in there.

• Overall
• Quality
• Value

OK bit of Gear

Jan 05, 2017

I have managed to get SBus in and PWM out, PPM in and PWM out, but haven't managed PWM in yet as claimed below in other reviews. I have tried FrSky V8FR-II and V8R4-II and a Orange RX with a DX6 but got no response with PWM input.
Success with a D4R-II on CPPM and a Orange RX on SBus.
Ok on the 1 - 8 and 9 - 16 channels as well.
I can't get my A3 gyro to operate on SBus but it is OK on CPPM in - PWM out mode.

• Overall
• Quality
• Value

Customer Rated

May 10, 2016

Excellent little piece. Used this to reduce the cabling on an Inside F5J glider, where it was built into the middle of the 6-servo wing, necessitating only one cable to go into the fuselage. No Manual is included, but it's pretty self-explanatory. Futaba users: make sure you connect it to an SBUS channel, not an SBUS2 channel. We've witnessed some servo jitter ("hiccups") with one of the three Units we purchased when used with a Futaba R7008 Receiver, but only on one of the unit's channels. Plugged the servo into another channel and all went well.

• Overall
• Quality
• Value

Customer Rated

May 05, 2016

WORKS ON DJI D-BUS TOO!! FOR YOU FELLAS THAT USE LIGHTBRIDGE 1 WITH WOOKONG OR NAZA AND DONT HAVE FREE CHANNELS TO USE YOUR GIMBAL CONTROL AND SHUTTER!!

• Overall
• Quality
• Value

Customer Rated

Mar 09, 2016

BIG CORRECTION PREVIOUS POST. THE UNIT DOES DO PPM TO PWM.
The conversions are thus:
PPM in (Blue LED flashing once in short intervals) you get S-Bus out(ch10) and PWM out
PWM in (Blue LED flashing twice in short intervals) you get S-Bus out(ch10) and PPM out(ch9)
S-Bus in (Blue LED flashing three times in short intervals) you get PPM out(ch10) and PWM out
Works great.
The red LED OFF means the units PWM outputs are Ch1 to 8. The red LED ON means the units PWM outputs are Ch9 to 16. To toggle the red LED - hold down on the units tiny switch while applying power.
This unit works great.

• Overall
• Quality
• Value

Customer Rated

Mar 09, 2016

Great for converting S-Bus to PWM. Up to 16 channels. Disappointing to find it does not convert PPM to PWM. No instructions with the unit.
So here is a brief rundown on what the LEDs mean.
Red LED on means PWM is channels 9-16. Red LED off means PWM is channels 1-8. To switch the red LED on or off, you power up the unit while holding down the units tiny switch. Solid blue LED means no signal. Blue LED flashing twice in short intervals means PWM to S-Bus/PPM conversion. Blue LED flashing three times in short intervals means S-Bus to PWM conversion.