Control Steel Clevis Set

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 01, 2013

perfect for pull pull configurations.

I believe that hobby king should make pairs of those... they are cheap as chips and almost everywhere you use two of those.

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 04, 2009

Mmm, they look really solid, good thread a little loose when you try the maximum extension. Gap in between is 2mm. I use these on a swing wing f14 foamy for the wing swing mechanisme. I got 4 of them. some of them didn't line up really good, one of them had a loose centering pin. The plane flies oke with these. So they are oke but not top notch. 3 stars.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 28, 2009

ottimi ed economici. Consigliatissimi

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 28, 2009

The internal thread,3mm, is a little sloppy. This is solved by using a 3mm nut to lock against the clevis.The external threaded joiner has an internal hole of 2.5mm for soldering wire or CA carbon rod. I cross drilled the small hole and used swaged cable for a closed loop rudder on 1/4 scale Citabria. Nice and strudy. 5 stars

• Overall
• Quality
• Value

Customer Rated

Jun 04, 2009

Quality is OK for this price but the spring steel is not really "spring". So it's recommended to fix the clevis with a short peace of heat shrink tube or silicone tube (fuel tube) to avoid any problems.

Also it's better to solder or glue the bushing because it's only bended (not a closed tube)

• Overall
• Quality
• Value

A must have!

Nov 14, 2007

These are a must have if you are using carbon fiber or music wire control rods! For music wire, simply wrap some thread or dental floss around the end of the wire and CA it into the threaded receiver. These are very high quality and very useful in the supply box.