Turnigy D3536 / 5 1450KV Brushless Outrunner Motor
Bateria: /7.4~14.8V 2 ~ 4 celular
Max atual: 45A
Nenhuma corrente de carga: 3.5A
Potência máxima: 655W
Resistência interna: 0,023 ohm
Peso: 102 g (incluindo conectores)
Diâmetro do eixo: 5mm
Tamanho Prop: 7.4V / 9x6 14.8V / 8x4
Max impulso: 1380g
Características do Produto
Peso ( g )
Kv ( rpm / v )
Correntes Max (A)
Comprimento B (mm):
Pode Comprimento D (mm)
Max Tensão ( V)
Shaft A ( mm):
Unit Weight (g):
Diâmetro C ( mm )
Comprimento Total E ( mm)
Resistência (MH ):
Great motor, great price. Use with 3s and a 12x6 prop or 4s and a 10x6 prop for great performanceI use this motor in MPX dogfighter with 9*6 folding prop. The speed of the plane is about 120 km/h. Use with HK 50 A ESC (green). AUW 860 g, flight time: minimum 15 minutes!Sehr guter Motor passt perfekt im Skipper XLQuality of motors looks good.
But motor did not start , found all 3 soldering to cold-connectors of very poor quality .
After resoldering , motor runs fine.
Great motor for upgrade to many different 1100 mm wingspan planes. Make sure you also upgrade the ESC...I put two of these in a sky mule and wow POWER is all I can say this thing will match my 60" 3d plane in a clime well I think I didn't actually check but it has unlimited vertical till its out of sight in very little time not actually out of sight but a very small speck of a plane. They came down a little warm I don't know how warm I didn't have a thermostat with me but it wasn't bad on stock propellers. Basicly they are like most brushless motor that i've used before.I put this in a RadJett 800 4s 1300mah 45c lipo 35amp esc 7x5 apc prop this setup is incredible unlimited vertical twists the airframe when I run up the mtr not for the novice very nice smooth running mtr no complaints here over 50 flights still like new.Motor perfecto para el FPVRaptor v2 y v1, es el perfecto sustituto al de serie.
Muy importante que el eje es de 5mm.top quality motor
i use this one in my 1600 mm pusher glider and it is a great motor!works perfect with turnigy plush 60 amp and 8*6 folding propTested with 3s LiPo, no load.
- current draw 5.2A, (Power 64W)
- 17516RPM (1435kV)
- Shaft had slight vibrations
Conclusion: Not so precise motor, and high current draw can be caused by not good bearings
Somente usuários registrados podem fazer o upload de arquivos. Por favor Registre-se para que você possa começar a ajudar seus colegas de hobby hoje ainda!Customer files