Full Metal Servoless se retrai com Assembleia Steerable nariz e pés Oleo - de alta qualidade sistema de servoless retrair para modelos pesando até 3 kg, apresenta toda a construção de metal de precisão, confiabilidade e durabilidade, também possui auto de corte para protecção contra o consumo excessivo de corrente. Incluem-se um conjunto de pernas Oleo de qualidade e rodas de plástico com pneus de espuma. Finalmente, uma alternativa confiável para o ar e mecânicas de sistemas de retração para seus modelos!
Idealizado para Habu EDF
Tamanho Pin: 3mm
Rodas: 24 milímetros
Pneus: 45 milímetros
Peso: 58g cada (Mains) 60g (unidade Nose)
Max Modelo Peso: 3 kg
Tensão de funcionamento: 4.8V ~ 6v
Inclui 3 vias cabo de ligação
Características do Produto
Peso ( g )
Bought these for my Habu 32 to replace eflites that bent with even the gentlest landing on grass. The mounting holes are identical to the fitted eflites but you will need to make up extensions to the oleos, otherwise not too much modification needed - just a bit of dremelling here and there.Foam wheels and CHEAP plastic wheels. I performed about 45 seconds of low speed taxiing and the spokes on a main rim broke, and the front tire fell off and the front rim broke in half on decent asphalt. After upgrading wheels I had the struts repeatedly loosen I had to remove them and grind flat spots on the retracts, and drill and tap the M3 grub screws for M4. Only good on 70MM foam and smaller type A/C under 3.5 lbs I would say.Works very well on Habu2Good value for the money. Workmanship seems good so far. Bench testing, all retracts are working. I put an obstruction in, and they stalled and stopped as they should. Then recovered on the next cycle. The biggest problem is these are NOT "ideally suited for the Habu". The struts are too short by an inch (25.4mm) or more. And the wire pin that holds the strut to the trunion is too thin to hold up. They are not as big a diameter as the stock eflite strut even. I will have to drill out the holes, install a longer, bigger dia pin to make the wheels reach the wheel well cavity. This is not beyond the skills of an experienced modeler, but the necessity to do this modification should have been in the product description. The other issue is the wheels barely fit at all in the wheel well. They will have to be sanded down. The CROWN rating isn't mine. HK seems to control this, so what's the point of having a rating. I give it 4 crowns overall, 5 for value, 5 for value, and a 3 for the incorrect description.retracts good. but I have two flights after one stopped working. where to find an electrical part?
motor - a whole, and the scheme does not work.Nice and sturdy retracts, smooth and slow retracting actions. Built quality is very good as well. The main gear can be installed 90 degrees from the default orientation. Will be using it on my single 70mm F-22.
The measurement at the product description page is not very helpful so I did some measurement when the gear is extended.
From mounting plate to wheel axial:
Main Gear 75mm
Nose Gear 98mm
Somente usuários registrados podem fazer o upload de arquivos. Por favor Registre-se para que você possa começar a ajudar seus colegas de hobby hoje ainda!