Preço total

0,00 €

Carrinho de compras 0 Carrinho de compras 0 Loading...

Turnigy2836 Brushless Outrunner 1000kV

Generating Links

Turnigy2836 Brushless Outrunner 1000kV

Preço:

Now save guardar 0,00 € 0,00 €

18,63 €
Status:
Indisponível!
SKU:
T2836-1000
Envio Grátis? Clique aqui aprender mais!
Dimensão: 28 milímetros x 37 milímetros, 55 milímetros (com eixo)
Peso: 80 g (kv1000) (não incluindo conectores)
Diâmetro do eixo: 4 milímetros
Comprimento do eixo da frente: 14 milímetros
Espessura de laminação:. 2 milímetros
Tipo de magneto: 45SH

desempenho Max
Tensão: 3S
Prop: EP10x5
Thrust: 1000g
Potência: 300W
Para
3D 800-1000g
1200g + instrutor



  • Kv ( rpm / v ) 1000.00
  • Correntes Max (A) 27.00
  • Resistência (MH ) 0.00
  • Max Tensão ( V) 11.00
  • Potência (W) 300.00
  • Shaft A ( mm) 4.00
  • Comprimento B (mm) 37.00
  • Diâmetro C ( mm ) 28.00
  • Pode Comprimento D (mm) 22.00
  • Comprimento Total E ( mm) 58.00
attributeset-10
Close

Dimension Diagram Guide

  • attributeset-10

Close

Envio vídeo

Registre-se para enviar vídeos, por favor assinar em ou registar

Registre-se para escrever comentários, por favor assinar em ou registar

fred | Comprador Verificado

  • Overall
  • Value
  • Quality

works as advertized

Dec 29, 2019

great little motor

Chris | Comprador Verificado

  • Overall
  • Value
  • Quality

Powerful motor

Dec 14, 2017

I fitted this to a depron SE5A with an 8x4 apc prop. It has about 30 flights on it now, has never missed a beat and always comes down cool. The plane takes off like a rocket too!

eliasin | Comprador Verificado

  • Quality
  • Value
  • Overall

Customer Rated

Jun 10, 2016

Malisimo motor, Lo puse en un phoenix glider 2000 y se sobre calienta y deja de funcionar, esto con una folding prop 10x6 a 3s :((

crash69uk | Comprador Verificado

  • Quality
  • Value
  • Overall

Certified Buyer Rated

Aug 21, 2015

purchased this as a replacement motor in my Phoenix 2000 glider, I had to push the drive shaft through to other side to allow fitting, but not a problem. Initial set up using a 3s 1300 fully charged battery and a 10x6 carbon folding prop provided the following results 53 amps and 370 watts, far too much for this motor, then swapped the prop for a 9x5 and got the following 24 amps and 275 watts.

Havenow flown this combination on a number of occassions and it works great, good rate of climb and then switch off motor for a good Gliding session, this is a glider after all and NOT intended as a hotliner

Stuart | Comprador Verificado

  • Quality
  • Value
  • Overall

Customer Rated

Jan 29, 2015

Motor lacks quality. 1000kV seems to be an underestimate... maybe more like 1400kV. Installed it on phoenix 1600 glider, ran it with stock 10x6 prop and burnt out in 2 minutes. I should have checked the wattage... my bad. Purchased a new prop 9.5 x 5. Anyway, got a second motor and this time the windings weren't as tight as the last one... some loose wires near the top. When I gave it full throttle there was some wicked vibrations hard to know where this was coming from. When being very gentle with the throttle the motor would still get way too hot to touch.

Now running NTM 35-30 1100kV with variety of props and works as I would expect and is just warm to the touch after throwing the plane around.

kikou | Comprador Verificado

  • Quality
  • Value
  • Overall

Certified Buyer Rated

Dec 13, 2014

a nice and strong engine, i use these motors for al ong time, and i m totally happy with . use with a 3s lipo 2200 mah and 10x6-11x6

Dazzer -Bris | Comprador Verificado

  • Quality
  • Value
  • Overall

Certified Buyer Rated

May 29, 2014

put this motor in my phoenix 1600 glider with 9 x6 prop motor runs cool and has heaps of power would highly recommend this motor

modevil | Comprador Verificado

  • Quality
  • Value
  • Overall

Customer Rated

May 29, 2014

Overall good motor which I use in Graupner Elektro-Trainer (total weight above 1 kg). With 3s battery and 10x5 prop the plane is not overpowered - unlimited vertical flight is not possible but basic aerobatic maneuvers are fine. After more than 30 flights I can feel some play on the bearings and also the motor gets warm after 10 mins flight. So it is not the highest quality product but will serve for some time.

marco tamayo | Comprador Verificado

  • Quality
  • Value
  • Overall

Customer Rated

Apr 13, 2014

No tuve tiempo de nada, en su segundo uso se quem. no vuelvo a comprar estos motores de bajo precio. Ya tengo 6 desechados.
Aqui mismo consigue de mejor calidad, gastese unos 3 o 4 dolares de mas y compre algo que valga la pena.

HeyOB | Comprador Verificado

  • Quality
  • Value
  • Overall

Customer Rated

Oct 19, 2013

I bought this motor several years ago and finally had an application for it . I installed it on a speed build Flite test spitfire. Awesome motor with plenty of power ! I reversed the shaft for this build which was no big deal . This motor runs like a champ , I paired it up with a 30amp plush ESC and a Turnigy 2200 mah battery .

Subir arquivo

Registre-se para fazer upload de arquivos.
Por favor assinar em ou registar para começar a ajudar amadores agora!