A água de refrigeração Jacket Para B4563 Motor - Super Versão & Crusher Surge
Características do Produto
Peso ( g )
I got this part ! I would like to mount it on PRODUCT ID: KB45-10L .
For me it is very disappointing :
The diameter inside it`s a lot more than 45 mm.
No seal contains. So you have to glue it to your engine.
The hose connectors are much smaller than the thread in the jacket. So you can`t screw them in !J'ai reu le mme article sans joints toriques, il n'y a pas de rainure usine dans le mtal pour les tenir. WTF? Je suis perplexe comment retenir l'eau " avec du silicone " comme a cela fait un montage propre !!now occurred to me after looking at the picture, it may be that mass-produced rc boats stuck on the motor pad/glue/stuck whit some white silicone adhesive paste or glue and this paste is not as a replacement whit cooling jacket. I think that such a silicone paste or glue can get elsewhere. Thus, if it is not designed for o-rings.But inside the shell seems to me very rough for the o-rings installed.and the sloping edge is smooth - accurate to the application of the adhesive silicone paste.
Jacket not necessarily bad, but the instalation O-rings is other. According to the shape of the edge of the jacket was first pushed onto the motor and then be given on-rings. There's probably pressed some hoops to not damage the o-rings. In this procedure does not require installing o-rings in milled grooves.
I received this item without o-rings. Also there is no groove machined into the metal to hold them. WTF? Anyone got any ideas? I'm baffled.
Somente usuários registrados podem fazer o upload de arquivos. Por favor Registre-se para que você possa começar a ajudar seus colegas de hobby hoje ainda!