The RadioMaster RP V2 series of receivers now have a built-in TCXO (Temperature-Compensated Xtal Oscillator). The TCXO ensures high stability and accuracy in frequency control and compensates for temperature variations. This results in consistent and reliable signal reception, even in extreme temperature conditions. It also reduces frequency drift over time, providing long-term frequency stability and preventing signal degradation. This provides a superior performance in demanding environments and enhances the flight experiences.

The RP2 2.4GHz ELRS Nano receivers use the high-performance, revolutionary ExpressLRS open-source system. The Nano receivers were designed by the ExpressLRS development team, and feature the ESP8285 MCU and SX1280 RF chips. WiFi is built-in so that you can easily upgrade the firmware and configure the receiver using your PC or mobile phone. Other features of the RP2 V2 are improved solder pads and a super lightweight built-in ceramic antenna.

Due to the low-latency and high-refresh-rate RF module, this receiver is ideal for FPV racing or long-range flying. The RP2 Nano receiver is available in either an FCC or a European LBT version, please check the specifications below for the supported protocol.

Features:
• Improved PCB design for better heat dissipation
• Super lightweight built-in ceramic antenna
• Available with either FCC or LBT-compliant protocols (see specs for details)
• Improved solder pads making the solder joints easier
• Built-in a TCXO (Temperature Compensated Xtal Oscillator) for accuracy and stability
• Compatible with 2.4GHz ExpressLRS modules and transmitters

Specs:
Product: RADIOMASTER RP2 V2 LBT ExpressLRS 2.4GHz Nano Receiver
Frequency Range: 2.404 - 2.479 Ghz
Compliant Protocol: LBT
Firmware Version: ExpressLRS V2.4 pre-installed
Type: ISM
MCU: EPS8285
RF Chip: SEMTECH SX1281
Telemetry RF Power: 10mW
Antenna: Built-in SMT antenna
Maximum Refresh Rate: 500Hz/F1000Hz
Minimum Refresh rate: 25Hz
Input Voltage: 5V
FW Target: RadioMaster RP1/2 2400 RX
Bus interface: CRSF
Dimension: 13mmx11mmx7mm
Weight: 0.55g

Includes:
1 x RADIOMASTER RP2 V2 LBT ExpressLRS 2.4GHz Nano Receiver
1 x CRSF wire
1 x User manual

Please note: A copy of the User Manual is available under the "Manuals/Files" tab.