HobbyKing 3D Волокно Принтер 1.75mm ABS 1KG золотника (черный)

• Overall
• Quality
• Value

Average cheap Chinese ABS

Mar 30, 2021

This ABS is very similar to many other low cost Chinese brands (probably the same). It prints fine. Colour density is sometimes less than I would like. Strength and bonding is good, suspect the ABS is not blended with anything else. Packets have some debris inside on opening. Good for structural parts.

• Overall
• Quality
• Value

Exceptional ABS

Apr 29, 2020

Like most ABS, this filament is a bit tricky to get dialed in. My Voron with a Volcano likes this filament at 250C with a bed temp of 105C. From there, I use a 0.3mm first layer to ensure a good stick to the bed. Beyond that, this filament prints as good as any Esun or Hatchbox ABS I normally print with. Low warping and good layer adhesion. Exceptional value.

• Overall
• Quality
• Value

not bad at all

Apr 17, 2020

got this over a year ago now when i first purchased my printer, its been out of the packet for most of that time. still prints perfect even better than another more expensive brands abs and abs+
235C/100C perfect finish and cant fault the layers

• Overall
• Quality
• Value

Really good value

Apr 13, 2020

This stuff prints like butter. Printing at 250 hotend and 100 bed. You can't go wrong with this abs.

• Overall
• Quality
• Value

ABS FILAMENT

Aug 29, 2019

This filament is better then all the other brands of ABS I have used and I have been printing for 7 years.

• Overall
• Quality
• Value

Great for the price

Oct 08, 2018

So inexpensive using a Prusa P3 steel clone with a bunch of tweaks. I run this hot around 250-260 with 10% fan(after first layer or two), that works well for me to balance quality and strength. If strength isn't important then dropping the temp down will give better surface finish to the parts.
Overall though good stuff, ordering 5 more spools right now.

• Overall
• Quality
• Value

No amazing

Jun 19, 2018

Item suffers from colour variance and also low layer bondage strength. Tried from 235*C through to 255*C in temps and in all cases the layer bondage is really low (enclosed and heated build chamber with no cooling fan). Simply removing a print can cause layers to break away from each other if the wall thickness is less than 4 layers, the black is not as bad as the other colours but still pretty bad.
Best suited to prints with thick walls or a bunch of infill to support the poor layer adhesion.

• Overall
• Quality
• Value

Very good for the price

Feb 09, 2018

I got some decent prints at 245°C and heated bed at 105°C, without a fan.
Obviously not as good as the double or triple priced filaments, but good enough - will buy more.

• Overall
• Quality
• Value

Quality Cheap Filament

Jun 11, 2017

Printed on my Original Prusa I3 mk2s at 235c. The filament itself is quite runny. I ran it quite cool with a 10% fan after the 1st layer. It prints flawlessly! Even better it acetone smooths amazingly! highly recommended!

• Overall
• Quality
• Value

Customer Rated

Sep 03, 2016

This prints very well. Smooth and strong. Had no problem getting it to stick to kapton tape with glue stick. This is a bargain.