HobbyKing 3D Волокно Принтер 1.75mm ABS 1KG золотника (красный P.186C)

• Overall
• Quality
• Value

A Very Decent ABS

Feb 11, 2017

I found this to be easily printed (for an ABS, so you still need a heated bed etc.) and the diameter was accurate and even. For me I got a somewhat matte finish when printing at 240C/60mm/s, a little bit glossier at 245C/60mm/s and a bit better layer adhesion.
The color (Red P.186C) is not very bright but rather peachy or a bit sun washed.

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 23, 2016

matière parfait pour nos impression 3D, utilisé sur malyan M150, M180 et minifabrikator!! prix plus que attractif dans un support parfait. j'adore !! je le recommande les yeux fermés

• Overall
• Quality
• Value

Customer Rated

Aug 12, 2016

Nice filament, havent had any problems with it yet but you need to print it in an enclosure with a bed temp of about 100 degrees and between 235 and 240 degrees extruder temp with abs juice on a glass bed.
Don't forget to use it in a well ventilated room or suck the vapours out of the enclosure out of a window!
I am using a small 60mm fan on 7 volts and a vacuum cleaner hose to suck out the vapours while maintaining a steady temp inside
I am using a malyan m150 i3 with 40mm/s printspeed