Раскладной Пропеллер Вт / концентратор 35 мм / 3 мм 6х6 (2 шт)

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 19, 2016

Excelente para modelos minitermicos motorizados electricamente

• Overall
• Quality
• Value

Customer Rated

Mar 07, 2014

These seem to be decent quality, but one of the two I received had a horrible vibration to it. Upon closer inspection I noticed the hole in the nut that fastens down the yoke was way off center, causing the entire assembly to vibrate. The nut on the 2nd spinner was better, but still off center and caused vibration. There's no way I'll attempt to use this spinner without going to the hardware store and finding a better nut.

• Overall
• Quality
• Value

Customer Rated

Jul 07, 2013

When i first flew 7" prop on my glider with this I thought something was wrong with the motor, had to give 75pcntpower or more. when I put on a 7" APC prop it had twice the power and can cruise less than half throttle. one thing i notice is the spinner hub takes up 1- 1/4" inches so its not a 7" prop but a 5-3/4" I think I will always add more than an inch to my next order to compensate.

• Overall
• Quality
• Value

Certified Buyer Rated

Apr 15, 2013

well built and needs a Little balance!

• Overall
• Quality
• Value

Customer Rated

Dec 09, 2012

I have 6*3, 6*4, and 6*6 and can't tell the difference between them by sight or by measurement. They all have the same pitch despite the stamped numbers and draw the same current. Very inefficiently at that too, took an 8*4 APC to match amp draw and the APC had way more thrust obviously. If you don't mind that they are ok.

Richard

• Overall
• Quality
• Value

Customer Rated

Jun 06, 2012

I use them on my AXN Floater-Jet with standard motor. Much better climb rate but less speed.
They came very well balanced.

• Overall
• Quality
• Value

Certified Buyer Rated

Apr 15, 2012

very well made, balanced