FPV передатчик и 1/3-дюймовый ПЗС-камера PAL

• Overall
• Quality
• Value

Customer Rated

Jul 15, 2012

Haven't ranged tested this TX will do in 2 Weeks.
Caution check the polarity of the cable that plugs into the camera module before power up! My positive and signal wire were reversed, you can read it on the camera module. Tested at night worked a ton better than expected! Going to solder cloverleaf antenna to board and test range will document tutorial on my website www competefornothing com

Very impressed with this combo so far!

I am pretty sure these are the channels....
1 - 2410
2 - 2430
3 - 2450
4 - 2470

I have tested channel 1 with AIO 640x480 goggles sold here for $360

• Overall
• Quality
• Value

Customer Rated

Jul 15, 2012

Haven't ranged tested this TX will do in 2 Weeks.
Caution check the polarity of the cable that plugs into the camera module before power up! My positive and signal wire were reversed, you can read it on the camera module. Tested at night worked a ton better than expected! Going to solder cloverleaf antenna to board and test range will document tutorial on my website www competefornothing com

Very impressed with this combo so far!

I am pretty sure these are the channels....
1 - 2410
2 - 2430
3 - 2450
4 - 2470

I have tested channel 1 with AIO 640x480 goggles sold here for $360

• Overall
• Quality
• Value

Customer Rated

Jan 02, 2011

I just received the NTSC version of this.. I can't say I'm very impressed with the quality. It's not sharp at all. The colors are very weak. I have a standard Rx that has a tune dial. No problems getting a signal. I tried it in the garden to about 75 meters. My receiver was hooked to my main PC and I streamed the results to my laptop.. I ran out of laptop range before the camera went off. It was a bit crackly.. but I couldn't adjust the tuning, and the receiver was indoors, so not the best test. HobbyKing need to supply instructions. I have never had any instructions with anything I got from Hobbyking.

• Overall
• Quality
• Value

Customer Rated

Aug 10, 2010

As requested by many people - please find the usual 4 channel frequencies below:



CH1=2414MHz

CH2=2432MHz

CH3=2450MHz

CH4=2468MHz



Hope this helps -)

• Overall
• Quality
• Value

Customer Rated

Aug 10, 2010

Good video quality and TX is incredible small. Without jumper the TX transmits on channel 4 (2469 MHz). I use it with a common 4 channel USB RX on my netbook.



A connection kit for Eagletree OSD would be great -)



I can recommend this set!

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 25, 2010

Everything looks i'm still weighting for my receiver to test it, I had put it together to how it is set up it was easy but i don't know what the yellow, white and red wire are for.

• Overall
• Quality
• Value

Customer Rated

Jul 25, 2010

I get only 4 stars due to lack of documintaion. great reange and decent cam for the little money I spent. works great with my FatShark Goggles.

• Overall
• Quality
• Value

Customer Rated

Jul 07, 2010

Los canales del emisor se corresponden con los de la fat shark

• Overall
• Quality
• Value

Customer Rated

Jul 01, 2010

here is a test http://www.youtube.com/watch?v=am8b1tFbkQA

• Overall
• Quality
• Value

Customer Rated

Jun 15, 2010

A 500 m/watt 1.2 gig would be the best

900meg is used for cell phones so no good in SA and UK.