GWS S03N2 D HP2BB 30g / 0.10Sec / 6.6kg Цифровой сервопривод

• Overall
• Quality
• Value

Customer Rated

Nov 19, 2013

****!!! Ordered five of these and two died almost instantly. Did not even finish getting them setup. Now I am stuck whether to order replacements or change them all out. To add to it now they are out of stock!!!!

• Overall
• Quality
• Value

Customer Rated

Sep 03, 2013

I put these on my MXS as an upgrade from my HK-752's and they are good. One started to jitter, but that was because I tried running that one on 7.4v. Overall, it's worst the money. SO GO OUT AND BUY!!!

• Overall
• Quality
• Value

Customer Rated

Oct 15, 2012

hoi
ik heb er 6 stekken in een jak van gb models 1.80 sp
zeer goede servo's met perfect mindelpunt
voor die prijs ,zeer goed
dank u hobby king

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 24, 2011

On the bench, very quick and powerful @ 5 and 6V.



1mm overshoot in one direction on centering, on an 80mm arm attatched to the servo.

(Minimal at the end of the servo arm)



Did disassemble one, all wires are glued down, so no problems with wires breaking off.



Pcb board a little crooked, but not loose. Could use a bit of glue along the sides of the Pcb board to make sure it does not move in the future.



Ball bearings top and bottom of main gear.

No slop in the gear train whatsoever.



O rings (2) in the servo case, and 1 o ring on the output shaft as well.



So far, looks good.



(psalso takes Futaba servo arms!!)



Photos on forum under "servos".



Bj.