hexTronik DT700 Brushless Походный 700kv

• Overall
• Quality
• Value

bien adapte

Apr 22, 2020

ce moteur fonctionne très bien sur le B17 V2 mais le rend un peut lent

• Overall
• Quality
• Value

muy mala calidad

Nov 03, 2019

mala terminacion..lambre ce conexion muy rgido y fragil. antes colocar hay que cambiar ese alambre

• Overall
• Quality
• Value

Customer Rated

May 14, 2015

very powerful bell motor, i ts almost equal in performance with a 35xx motor 920k, except that its half the price , also it can handle 4s easily, if 10-12`prop-=25amb esc
if 13 prop= 30 a esc

• Overall
• Quality
• Value

Customer Rated

Apr 30, 2015

Using this motor with a 30 Amp car ESC for an ROV project. So far preliminary tests are working nicely. It produces quite amount of thrust with my 57mm boat props, while submerged. the only problem I've had is that the set screws in the base seem to strip fairly easily, and I've had to drill an indent to keep the control wires from coming loos and flopping around.

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 22, 2015

It's a good product. It works as it should be.

Two thumbs up. I would like to recommend it to all user.

• Overall
• Quality
• Value

Customer Rated

Oct 02, 2014

cheap work well and very efficient. the one and only down side is I have had 2 out of 4 have magnets come loose. I hope hk can in prove on their quality of products.

• Overall
• Quality
• Value

Customer Rated

Apr 08, 2014

These motors are ok for scratchbuild multirotors, but you will soon find they are a bit sluggish. You need to epoxy the wires which I am sure has been stated, but I ruined two motors before I did it correctly. I used Amazing Goop for ease. I have these on an h-quad, but they make a lot of vibration. I think all bells have that as they have such a small support, but large bell. For the price I'm sure you can find better motors that spin freely and have no need for modification.

• Overall
• Quality
• Value

Certified Buyer Rated

Apr 05, 2014

Good motors ....for the price....the issue is you can't really tighten props as if you try to screw the props too tight the shaft has a tendency to slip and cause the end ring clip to push against the bottom bearing causing the motor to run like its a bit jammed...gummy feel...I would go for the zip tie method to mount props....better bearings would be great....and neater windings would make this a killer deal....I don't think patrons would mind paying a couple of dollars more for this...all in all it is a great motor for a cheap not so trusty multicopter

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 13, 2014

Superb item to use in all RC stuff. Just safe peace of mind that you have a tad better item in your gear. Buy with confidence

• Overall
• Quality
• Value

Customer Rated

Jan 18, 2014

good motor, altough winding is not the best quality.

If you crash your plane and shaft bends, there is no replacement parts for it.