KD36-60-08L 3000kv Brushless Inrunner (15T)

• Overall
• Quality
• Value

Customer Rated

May 23, 2012

Use this on my Hawk F5B training hotliner..

With Gear 4:1 and Carbon prop RF 15x13 the plane is accelerating vertical. After 2 sec out of sight.

No external cooling and motor makes 25 sec. total run time per flight.

Temperature is warm but still exceptabel.

Good value for money. Deal!

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 12, 2012

Use in 1/8 scale buggy with HK 80A Car ESC, fast on 14.8V (4S) lipo, not getting hot at all

• Overall
• Quality
• Value

Customer Rated

Jan 03, 2012

Using this with the Birdie 100A (w/5A bec) water-cooled ESC on a 70cm mono-hull with a 40mm prop on 2 cell Lipo. Setup currently pulls 80~83 amps max and the ESC gets warm (but not hot) with water cooling. My cooling setup is a rudder pick-up into a 36mm motor water jacket, then through a water-cooled motor mount, then though the ESC, and final out a side mounted water outlet hole. I will provide more updates as I run the setup more. :)

• Overall
• Quality
• Value

Customer Rated

Oct 12, 2011

Portugus: O motor demais, timo mesmo, muito forte e rpido, usei na converso de um Kyosho DRT, o carro ficou magnifico, anda muito mais, muito mais arranque, tive que configurar no controle, para que a sada inicial seja mais suave, e o freio tem que ser ABS, se no quebra a engrenagem, muito forte o motor. Obrigado HobbyKing.

Ingls: The engine is awesome, really nice, very strong and fast, used in the conversion of a Kyosho DRT , the car was magnificent, goes much, much more starter, I had to configure the control so that the initial output is smoother, and ABS brakes have to be, if not break the gear, the engine very strong. Thank HobbyKing.

• Overall
• Quality
• Value

Customer Rated

Jul 28, 2011

Great motor.I use it in my hpi mt2 electric conversion with hk 100 amp esc and 2 turnigy 2200mAh lipos connected paraller.I also bought TURNIGY Heat Sink with Fan and it keeps the motor temps low even after hard bashing.Thanks HK!

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 27, 2011

A very good motor.Gives really good power to my hpi mt2 E-conversion with HK 100A esc and 2x turnigy 2200mAh lipos connected in paraller.I also bought "TURNIGY Heat Sink with Fan for 36 series motors" and it keeps the motor temps really low even after hard bashing sessions.

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 09, 2011

crap crap crap crap crap crap crap crap crap crap crap crap crap crap crap crap crap crap

• Overall
• Quality
• Value

Customer Rated

Apr 02, 2011

if you have a Traxxas Slash 4X4 and are looking for more power this is the motor to use.

Pick up this motor, a 15tooth .8 mod 32pitch 5mm pinion, and a 52 tooth spur gear. And you will have slightly higher top end, but loads more torque and you only dare about 70 amps full throttle which means longer run time and a cooler motor and esc!
Mate this motor with a zippy 5000 mah 30C and your stock vxl esc. My moor temps after hard running is only 110F vs 165F stock, and I can wheelly on demand for an entire battery pack.

You will need to make some extension wires between you esc and motor ( if your using a Traxxas vxl) as the motor wires are only about 2 inches. The motor comes with 4mm female bullets to convert you esc with.

I would buy this again!.

• Overall
• Quality
• Value

Customer Rated

Nov 01, 2010

Bought this motor for a converted slash 4x4(turned it into a buggy). Torque
is incredible, stock gearing of 13/54 can be matched with this kv by using a 15/52. You will get about the same speed. Not near as hot as stock vxl motor and the stock speed control stays cooler, also slightly longer run times and a more linear feel on the throttle. Only problem is the rotor was shimmed too much, putting stress on the bearings, started ceasing after about 3 min of running. had to take apart and replace one of the shims with a washer half the thickness. works perfect now. even with the problem i still give it 5 stars because of the value.

• Overall
• Quality
• Value

Customer Rated

Sep 13, 2010

great motor for use in rc cars lower than 2kg......... powerful and cold...... I use in a associated tc5 and is awesome .......