MATEKSYS Flight Controller F411-WING

Flight Controllers for remote control aircraft help to keep the plane stable and can stop fliers getting into trouble. Depending on the sensors connected to them they can also be used to remotely pilot the aircraft over a controlled pattern. The Matek F411-Wing Flight Controller is designed to provide stable flight on RC aircraft that have up to two motors.

There are quite a number of configurations that can be used. These could be a standard airplane with ailerons, elevator and rudder or a flying wing or an aircraft with a “V” tail. The flight controller could also control the flight of the aircraft if you have sensors such as GPS, airspeed indicator, etc.

Power comes from a 2~6S Lipo Battery and the flight controller has BEC’s to provide power for devices such as servos, receiver, camera, buzzers, LED’s and other devices.

Get control of your plane with the Mateksys Flight Controller F411-Wing.

Features:
• STM32F411 Processor
• Up to two Motors
• Up to five servos
• Built-in BEC
• Current Sensor
• 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator (Red)

Specs:
FC Specifications:
MCU: 100MHz STM32F411CEU6
IMU: 6-axis MPU6000 accelerometer/gyro (SPI)
Barometer: BMP280 (I2C)
OSD: INAV OSD w/AT7456E chip
Blackbox: No
VCP & 2xUARTs
Outputs: 2xMotors, 5xServos
1x I2C
3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator (Red)
Built-in inverter for SBUS input (UART1-RX)
SoftSerial_Tx1: ST1 pad by default
PPM: ST1 pad with Softserial disabled
Battery Voltage Sensor: 1:10 (Scale 1100)
WS2812 Led Strip: Yes
Beeper: Yes
RSSI: No

FC Firmware:
INAV Flight
Target: MATEKF411
Power Distribution Board:
Input voltage range: 6.5~30V (2~6S LiPo) w/TVS protection
2x ESC power pads
Current Senor: 78A, 3.3V ADC, Scale 423

BEC 5V output:
Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED Strip, Buzzer, GPS module, AirSpeed
Continuous current: 2 Amps

BEC Vx output:
Designed for Servos
Voltage adjustable, 5V Default, 6V via jumper
Continuous current: 3 Amps

BEC 3.3V output:
Designed for Baro / Compass module/ OLED and Spektrum RX
Linear Regulator
Continuous current: 200mA

Physical Specs:
Mounting: 24 x 24mm, dia.2mm
Dimensions: 41 x 28 x 10mm
Weight: 7g (Total 12g w/ bottom plate and M2 standoffs)