Mini CC3D революция 32bit F4 на основе контроллера полета

• Overall
• Quality
• Value

Mini CC3D Revolution 32bit F4

Feb 19, 2018

Take care with online instructions, it does not support 12V, nevertheless very impressed with dimensions, easy to setup with Librepilot

• Overall
• Quality
• Value

Customer Rated

Nov 20, 2016

This is an excellent alternate miniaturization of the powerful CC3D Revo board. Apart from forgoing the integral OPLink telemetry modem, the RevoMini retains all the former's sensors and electronics. It also performs up to the standard Revo's standards in most flight modes.

One question is how this mini compares against the RevoNano, which is endorsed by the official OpenPilot developers, but also rare in the market.

• Overall
• Quality
• Value

Customer Rated

Oct 14, 2016

Looks like a good board to me. Soldering quality is good (for being lead free) and the components are well centered.
I loaded Betaflight 3.0.0 (board REVO) from the betaflight configurator 1.8.3 and it works but you have to put the board in DFU mode. First time you have to connect pin 64 to pin 60 using a pair of tweezers under a microscope and let someone else plug in the usb cable in the PC, then start betaflight configurator and flash with everything enabled except the manual baudrate.
If you want to flash again you just go into CLI and type "dfu" and then you can flash it again. No need to connect 60 and 64 again.
Betaflight configurator 1.8.3 has a problem to connect again after reboot so you have to restart the configurator and manually connect.
I have at this point not yet flown with this board, and I'm busy so it will probably be no flying for at least a week or two. But so far everything works including magnetometer and barometer.

• Overall
• Quality
• Value

Certified Buyer Rated

Apr 07, 2016

Easy to install and setup. All cables were included what I needed. Compact size, great performance.