Шестерней 3.17mm / 0,5М 10T (1шт)

• Overall
• Quality
• Value

Customer Rated

Feb 13, 2014

Sorry hk but this item is very poorly made, it's grub lock screw did not go deep enough
and lock against flat on shaft, so it part stripped out the first two threads. I had to round file a deeper groove on shaft to lock it in using loads of lock tight, hope QR is going to get better
in future, as I am already looking for other places to buy my rc gear from.

• Overall
• Quality
• Value

Customer Rated

Mar 22, 2013

I bought 3 of them. The hole is too small for 3.17mm motor shaft. I tried applying heat but still could not fit. Eventually I broke one of them by trying to hammer it on the shaft.

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 06, 2013

Be careful when you tighten the screw, thread brakes easily. I recommend filing the locking screw end flat, then thread goes little deeper and doesn't brake that easily.

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 02, 2012

what to say? 10teeth pinion for heli...lowering headspeed...

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 08, 2012

Good alternative to the "brand" name product. Cheap and affordable. Recommended.

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 23, 2012

ciao



acquisto consigliato, anche se gli originali devono essere migliori

questi, se non avvitati bene la prima volta, si spana il filetto del grano



ciao ciao

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 28, 2012

Smooth teeth but to little metal around the grub screw.

You need to make a deep flat spot on the aksel for the grub skrew to grab desent.

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 20, 2012

I used this with my HK-450V2 with Turnigy 450 H2218 Brushless Outrunner 3550KV motor lots of power 11.1v 35c-70c 3s1p battery. estimated 2800 HS

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 11, 2012

A pinion like a lot of others :) Good as it is.

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 17, 2012

I am using this pinion for scale applications in 450 helis where a higher KV motor is used. It helps to keep the amps low on the ESC. Take care in programming soft or very-soft start on your ESC so you will put less stress on the main gear.