S3674-1660 Бесщеточный Inrunner 1660kv (23T)

silnik ok do buggy skala 1/8

Awesome motor power output with less consumptions without not so much heating issue thanks hobbyking

What a beast of a motor! Fitted it to a new XRP18 blade 90mm EDF unit. Running 6S 5000mAh 40C with YEP100A ESC I saw just over 940watts at 32A on only HALF throttle. Held for 140 seconds (Too late at night here to run up fully)Motor and ESC virtually cold! I will run up fully on Saturday with full figures - unless it burns of course! If this runs up fully, HK please get more in ASAP!!!

when I put this in my hydroplane/boat it will turn 24,568 rpm's with a 14.4 volts and from what others are saying about the power...I'm excited to get it installed! Looks great and the water cooling sleeve I bought for it fits like a glove. Way to go HK.

Very nicely made inrunner although somewhat heavy. I tested it in the Changesun 12 blade 90mm EDf on 6S and found it to be unsatisfactory. Draw 105A/ 2100watts and became HOT fast ( 210F).
Nice motor but not for my application.

Got it as a freebie. Some of my RC car buddies sure need some motor time to time. I prefer planes atm.

I trust others and give 4 stars. So there can be better motors out there.

WOW...powerhouse to the MAXTREME! 8s on a 102mm EDF nearly ripped my ARMS off. don't think it would last too long but it got warm after it spooled its head off for 30 sec. Still have to try in flight but I think it will go hard.

t is rated incorrectly. much higher kv. It overheated at half throttle and demaged with a 40mm prop on 6s in a 24in cat with a water jacket.
Very good high performance

WOW this motor has so much power. I hooked this up in a very unconventional way. We used two of these motors with a 42/1 gear ratio and hooked it up to a sumo bot and it had so much power and speed!

I installed two of these motors on an old Losi LST. I truly believe this is the most power that this monster truck could handle. Two Zippy 14.8v lipo's power this beast. These motors got my vote!